User manual HOTPOINT SZ 12 AA1 D/HA

[. . . ] - LED light bulb (with the same features) only available from the Technical Assistance Service Light bulb LED light bulb Light type 2) If the product has LED lights, as demonstrated in the figures below, contact the Technical Assistance Service if you need a replacement. LEDs last longer than traditional light bulbs, improve internal visibility and are environmentally- Disconnect the appliance from the power supply, empty it, defrost it (if necessary) and clean it. Keep the doors slightly ajar to let air circulate inside the compartments. iN THE EVENT OF AN INTERRUPTION TO THE POWER SUPPLY Keep the doors closed so the food stays cold for as long as possible. [. . . ] In a way that prevents the ingress of water, humidity or condensation. Fill 2/3 of the ice tray (if available) with water and put it back in the freezer compartment. Use sharp or pointed objects to remove the ice under any circumstances. Removing the drawers (depending on the model) Pull the drawers outwards as far as they will go, lift them up and remove them. Make sure that the door is closed properly after putting the food back on the grilles/shelves. You can also freeze fresh The quantity of fresh food that can be frozen i1n22m4 _ho4usrs Is written on the rating plate. How to freeze fresh food: Arrange the food on the grille, if present (figure 1), or directly on the bottom of the compartment (figure 2) Put the food in the middle of the Coming into contact with food that is already frozen, keeping a Distance of about 20 mm (figure 1 and 2). For frost free models it is not necessary to carry out any defrosting procedures. The quantity and speed of frost accumulation varies depending on the ambient conditions and how often the door is opened. It is advisable to set the temperature colder or, if available, turn on the quick freeze function (see Quick Guide) four hours before removing the food from the freezer compartment, to prolong the preservation of the food during the defrosting phase. To prevent the water from escaping during the defrost, it is advised that you place an absorbent cloth on the bottom of the freezer compartment and wring it out regularly. The STOP FROST SYSTEM (available depending on the model) facilitates the defrost procedure for the freezer compartment. The STOP FROST accessory (figure 1) is designed to collect some of the frost that forms in the freezer compartment and it is easy to remove and clean, therefore reducing the time needed to defrost the inside of the freezer compartment. To remove the frost on the STOP FROST accessory follow the cleaning procedure demonstrated below. - Open the freezer compartment door and remove the upper drawer (figure 2). - Unfasten the STOP FROST accessory (figure 3) and remove it (figure 4), taking care not to drop it on the glass shelf below. Note: if the accessory is jammed or difficult to remove, do not keep trying to remove it, but proceed with the complete defrost of the freezer compartment. - Remove the frost on the accessory by rinsing it under running (not hot) water (figure 5). - Let the accessory drip dry and dry the plastic Parts with a soft cloth. - Reinsert the accessory by placing the back Part on the projections shown in figure 7-A, then refasten the handle of the accessory to the clasps above (figure 7-B). - Reinsert the upper drawer and close the door to the freezer compartment. It is possible to clean the STOP FROST accessory on its own without completely defrosting the freezer compartment. [. . . ] Carry out the following steps: - to make it easier to remove the compartment, we recommend that you empty (and possibly Remove) the lower door shelves - turn off the compartment - remove the compartment by rotating it upwards - remove the white plastic shelf under the compartment Note: it is not possible to remove the upper shelf and side supports. To use the "Zero Degrees" compartment again, carefully reposition the white plastic shelf under the compartment before inserting the drawer and turning the function back on. To have a larger refrigerator volume and to reduce energy consumption, it is recommended that you turn off the "Zero Degrees" compartment and remove the compartment. Clean the compartment and its components occasionally using a cloth and a solution of warm water (taking care not to submerge the white plastic shelf under the drawer) and neutral cleaning agents specifically for cleaning the inside of the refrigerator. [. . . ]