User manual HOTPOINT SDS 1721 V J

[. . . ] Description of the appliance Overall view The instructions contained in this manual are applicable to different model refrigerators. * Varies by number and/or position, available only on certain models. Before placing your new appliance into operation please read these operating instructions carefully. They contain important information for safe use, for installation and for care of the appliance. [. . . ] During operation, the back wall will be covered in frost or water droplets depending on whether the compressor is operating or paused. If the TEMPERATURE ADJUSTMENT knob has been set on high values with large quantities of food and with a high ambient temperature, the appliance can operate continuously, resulting in excessive frost formation and excessive energy consumption: compensate for this by shifting the knob towards lower values (defrosting will occur automatically). In static appliances, the air circulates in a natural way: the colder air tends to move downwards as it is heavier. The food should be stored as follows: 19 GB Food Fresh fish and meat Fresh cheese Cooked food Salami, loaves of bread, chocolate Fruit and vegetables Eggs Butter and margarine Bottles, drinks, milk Arrangement inside the refrigerator Above the fruit and vegetable bins Above the fruit and vegetable bins On any shelf On any shelf In the fruit and vegetable compartment bins On the shelf provided On the shelf provided On the shelves provided PURE WIND * It is recognizable due to the presence of the mechanism on the top part of the refrigerator compartment (see diagram). B A B A B • Place only cold or lukewarm foods in the compartment, not hot foods (see Precautions and tips). They will increase humidity in the refrigerator and cause condensation to form. Due to the special guides the shelves are removable and the height is adjustable (see diagram), allowing easy storage of large containers and food. Pure Wind maximises air circulation, improving the efficiency of the evaporator and helping to achieve the optimal temperature inside the refrigerator as quickly as possible each time it has been opened. The blown air (A) is cooled when it comes into contact with the cold wall, whereas the hotter air (B) is sucked up (see diagram). Cleaning the appliance • The external and internal parts, as well as the rubber seals may be cleaned using a sponge that has been soaked in lukewarm water and bicarbonate of soda or neutral soap. € The back of the appliance may collect dust which can be removed by delicately using the hose of a vacuum cleaner set on medium power. The appliance must be switched off and the plug must be pulled out before cleaning the appliance. Avoiding mould and unpleasant odours TEMPERATURE Indicator light: to identify the coldest area in the refrigerator. € The appliance is manufactured with hygienic materials which are odour free. In order to maintain an odour free refrigerator and to prevent the formation of stains, food must always be covered or sealed properly. € If you want to switch the appliance off for an extended period of time, clean the inside and leave the doors open. If the word “OK” does not appear it means that the temperature is too high: adjust the TEMPERATURE ADJUSTMENT knob to a higher position (colder) and wait approximately 10 hours until the temperature has been stabilised. Check the indicator light again: if necessary, readjust it following the initial process. If large quantities of food have been added or if the refrigerator door has been opened frequently, it is normal for the indicator not to show OK. Wait at least 10 hours before adjusting the TEMPERATURE ADJUSTMENT knob to a higher setting. Do not speed up the defrosting process by using any devices or tools other than the scraper provided, you may damage the refrigeration circuit. The refrigerator has an automatic defrosting function: water is ducted to the back of the appliance by a special discharge outlet (see diagram) where the heat produced by the compressor causes it to evaporate. [. . . ] The back wall of the refrigerator unit is covered in frost or droplets of water • This shows the appliance is operating normally. Verifique novamente o indicador: e, se for necessário, realize uma nova regulação. 100 – 200 mm til højre for markeringen for venstre panel. Kompressoren og kondensatoren udsender varme og skal have en god ventilation for at kunne fungere optimalt og klare det elektriske forbrug. [. . . ]