User manual HOTPOINT SBL 2021 F/HA

[. . . ] • The socket can withstand the maximum power of the appliance, which is indicated on the data plate located on the bottom left side of the fridge (e. • The voltage must be in the range between the values indicated on the data plate located on the bottom left side (e. If the socket is incompatible with the plug, ask an authorised technician to replace it (see Assistance). Once the appliance has been installed, the power supply cable and the electrical socket must be easily accessible. [. . . ] Fresh food must be stored in the top FREEZER and STORAGE compartment where the temperature drops below -18°C and guarantees rapid freezing. To avoid blocking the air circulation inside the freezer compartment, it is advisable not to obstruct the ventilation holes with food or containers. • Do not place glass bottles which contain liquids, and which are corked or hermetically sealed in the freezer because they could break. • The maximum quantity of food that may be frozen daily is indicated on the plate containing the technical properties located on the bottom left side of the refrigerator compartment (for example: Kg/24h: 4). • To freeze (if the freezer is already operating): press the rapid freezing SUPER FREEZE button (corresponding yellow indicator light illuminates), insert the food and close the door. The function is disabled automatically after 24 hours or when optimal temperatures have been reached (indicator light goes out); !This will help maintain the temperature inside the freezer, ensuring that foods are conserved for at least 9 -14 hours. ICE CARE tray The fact that they are situated on the top part of the freezer drawers ensures greater cleanliness: the ice no longer comes into contact with the food placed inside the freezer compartment; furthermore, the dripping of the water during filling is avoided (a lid to cover up the hole after filling with water is also provided). Check that the tray is ompletely empty and fill it with water through the opening provided. Excess water prevents the ice cubes from dispensing (if this happens, wait for the ice to melt and empty the tray). Turn the tray 90°: due to the connected compartments each mould fills with water (see diagram). When the ice has formed (minimum time approximately 8 hours) knock the tray against a hard surface and wet the outside so that the ice cubes come loose and take them out through the opening. MAX WATER LEVEL WATER LEVEL MAX WATER LEVEL MAX 16 Maintenance and care Switching the appliance off During cleaning and maintenance it is necessary to disconnect the appliance from the electricity supply: 1. To restore normal operation, it is sufficient to set the FREEZER OPERATION knob on the desired value. Holiday function To minimise energy usage when on holiday, it is not necessary to switch the appliance off. The appliance has a function which allows it to maintain the temperature of the refrigerator compartment at approximately 12°C (which can also be used to conserve make-up and beauty products). The freezer temperature must be set to the minimum value in order to preserve the food. oPERATION knob on A double acoustic signal informs you when it has been enabled. Replacing the light bulb To replace the light bulb in the refrigerator compartment, pull out the plug from the electrical socket. Access the light bulb by removing the cover as indicated in the diagram. Replace it with a similar light bulb within the power range indicated on the cover (15W or 25W). GB Cleaning the appliance • The external and internal parts, as well as the rubber seals may be cleaned using a sponge that has been soaked in lukewarm water and bicarbonate of soda or neutral soap. [. . . ] • The appliance has been installed between cabinets that vibrate and make noise. • The internal refrigerant makes a slight noise even when the compressor is off. The back wall of the refrigerator unit is • This shows the appliance is operating normally. covered in frost or droplets of water 19 Assistance GB 195079837. [. . . ]