User manual HOTPOINT PC 640 T GH AUS

[. . . ] PC 640 T X AUS PC 640 N T X AUS PC 640 T GH AUS Español Manual de instrucciones ENCIMERA Sumario Manual de instrucciones, 1 Advertencias, 3 Asistencia, 4 Descripción del aparato, 5 Instalación, 20 Puesta en funcionamiento y uso, 25 Precauciones y consejos, 25 Mantenimiento y cuidados, 26 Anomalías y soluciones, 26 English Operating Instructions HOB Contents Operating Instructions, 1 Warnings, 2 Assistance, 4 Description of the appliance, 5 Installation, 6 Start-up and use, 11 Precautions and tips, 11 Maintenance and care, 12 Troubleshooting, 12 Français Mode d’emploi TABLE DE CUISSON Sommaire Mode d’emploi, 1 Avertissements, 2 Assistance, 4 Description de l’appareil, 5 Installation, 13 Mise en marche et utilisation, 18 Précautions et conseils, 18 Nettoyage et entretien, 19 Anomalies et remèdes, 19 Warnings WARNING: The appliance and its accessible parts become hot during use. Children less than 8 years of age shall be kept away unless continuously supervised. This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Cleaning and user maintenance shall not be made by children without supervision. [. . . ] The manufacturer declines any liability should these safety measures not be observed. € it should not be bent, kinked or compressed; • it should not be in contact with the rear wall of the appliance or in any case with parts which may reach a temperature of 50°C; • it should not come into contact with pointed parts or sharp corners; • it should not be subject to any pulling or twisting forces; • it should be easy to inspect along its entire length in order to be able to check its condition. € The supply connection point must be accessible with the appliance installed. € The inner diameters of the pipe are as follows: 8 mm for LPG; 13 mm for Natural Gas. Checking the tightness of the connection Upon completion of installation, check the gas circuit, the internal connections and the taps for leaks using a soapy solution (never a flame). Also check that the connecting pipe cannot come into contact with moving parts which could damage or crush it. Make sure that the natural gas pipe is adequate for a sufficient supply to the appliance when all the burners are lit Duplicate Data Plate Where the data plate is obscured by cabinetry when the cooker is in the installed position, place a duplicate data plate on a surface of the cabinetry adjacent to the cooker. Adapting to different types of gas To adapt the hob to a different type of gas other than default type (indicated on the rating plate at the base of the hob or on the packaging), the burner nozzles should be replaced as follows: 1. Unscrew the nozzles using a 7 mm socket spanner, and replace them with nozzles for the new type of gas (see table 1 “Burner and nozzle characteristics”). Reassemble the parts following the above procedure in the reverse order. Once this procedure is finished, replace the old rating sticker with one indicating the new type of gas used. Replace the nozzles with models that are configured for use with the new type of gas (see Table 1). Replace all the components by completing the above operations in reverse order. € Adjusting the burners’ primary air : Does not require adjusting. Remove the knob and adjust the adjustment screw, which is positioned in or next to the tap pin, until the flame is small but steady. Having adjusted the flame to the required low setting, while the burner is alight, quickly change the position of the knob from minimum to maximum and vice versa several times, checking that the flame does not go out. If the device fails to work when the burners are set to the low flame setting, increase this low flame setting using the adjusting screw. Once the adjustment has been made, replace the seals on the by-passes using sealing wax or a similar substance. If the appliance is connected to liquid gas, the regulation screw must be fastened as tightly as possible. Once this procedure is finished, replace the old rating sticker with one indicating the new type of gas used. Should the gas pressure used be different (or vary slightly) from the recommended pressure, a suitable pressure regulator must be fitted to the inlet pipe (in order to comply with current national regulations). Post Installation Checks Perform post installation checks and ensure proper and safe operation before leaving. [. . . ] When installing the hob, follow the instructions provided in the paragraph on “Positioning” the appliance. € These instructions are only valid for the countries whose symbols appear in the manual and on the serial number plate. € When disposing of packaging material: observe local legislation so that the packaging may be reused. € The European Directive 2012/19/EC on Waste Electrical and Electronic Equipment (WEEE), requires that old household electrical appliances must not be disposed of in the normal unsorted municipal waste stream. [. . . ]