User manual HOTPOINT LTF 11S112 L EU

[. . . ] EN Precautions and advice This appliance was designed and manufactured in compliance with international safety standards. The following information has been provided for safety reasons and should be read carefully. If the appliance is sold, given away or moved, make sure the manual is kept with the machine. Read the instructions carefully, as they include important information on safe installation, use and maintenance. [. . . ] The supports can slide right and left to fit the size of the crockery. Tip-up compartments with adjustable position* The side tip-up compartments can be positioned at three different heights to optimize the arrangement of crockery inside the rack. Wine glasses can be placed safely in the tipup compartments by inserting the stem of each glass into the corresponding slots. To change the inclination, pull up the tip-up compartment, slide it slightly and position it as you wish. Wine glasses can be placed safely in the tip-up compartments by inserting the stem of each glass into the corresponding slots. *Only available in selected models with different numbers and positions. 28 The upper rack can be adjusted for height based on requirements: high position to place bulky crockery in the lower rack and low position to make the most of the tip-up compartments/sectors by creating more space upwards. The geometry of the rack makes it possible to place such small items as coffee cups in the area in the middle. EN Adjusting the height of the upper rack In order to make it easier to arrange the crockery, the upper rack may be moved to a higher or lower position. The height of the upper rack should be adjusted WHEN THE RACK IS EMPTY. The third basket is equipped with two sliding side trays to make the most of the height of the space below. If the rack is equipped with a Lift-Up device* (see figure), lift it up by holding its sides. To restore the lower position, press the levers (A) at the sides of the rack and follow the rack down. The upper rack cannot be used in the high position and with the tip-up compartments closed in a vertical position. € Parts in synthetic material which do not withstand high temperatures. The colours of glass decorations and aluminium/silver pieces can change and fade during the washing process. Damage to glass and crockery Caused by: A separate arrangement of the cutlery makes collection easier after washing and improves washing and drying performance. €Knives and other utensils with sharp edges must be positioned with the blades facing downwards. Tips: • Only use glasses and porcelain guaranteed by the manufacturer as dishwasher safe. € Collect glasses and cutlery from the dishwasher as soon as the wash cycle is over. 29 Detergent and dishwasher use EN Starting the dishwasher Measuring out the detergent A good wash result also depends on the correct amount of detergent being used. Exceeding the stated amount does not result in a more effective wash and increases environmental pollution. [. . . ] € Clean the seals around the door and detergent dispensers regularly using a damp sponge. This will avoid food becoming trapped in the seals, which is the main cause behind the formation of unpleasant odours. Preventing unpleasant odours Food residue may become encrusted onto the sprayer arms and block the holes used to spray the water. It is therefore recommended that you check the arms from time to time and clean them with a small non-metallic brush. [. . . ]