User manual HOTPOINT LSTB 4B00 RU

[. . . ] This appliance was designed for domestic use or similar applications, for example: - farmhouses; - use by guests in hotels, motels and other residential settings; - bed & breakfasts. Remove the appliance from all packaging and make sure it was not damaged during transportation. If it was damaged, contact the retailer and do not proceed any further with the installation process. € The water supply tap must be shut off and the plug should be removed from the electrical socket at the end of every cycle and before cleaning the appliance or carrying out any maintenance work. [. . . ] The number and type of wash cycles and options may vary depending on the dishwasher model. 9 EN Only use products which have been specifically designed for dishwashers. If you are using a multi-function product, we recommend that you add salt in any case, especially if the water is hard or very hard. ) If you do not add salt or rinse aid, the LOW SALT* and LOW RINSE AID* indicator lights will remain lit. Water Hardness Table level 1 2 3 4* °dH 0 - 11 12 - 17 17 - 34 34 - 50 °fH 0 - 20 21 - 30 31 - 60 61 - 90 mmol/l 1, 1 - 2 2, 1 - 3 3, 1 - 6 6, 1 - 9 Average autonomy salt dispenser with 1 wash cycle per day months 5 months 3 months 2 months 2/3 weeks Measuring out the refined salt For values between 0°f and 10°f, we do not recommend the use of salt. The use of salt prevents the formation of LIMESCALE on the dishes and on the machine's functional components. The salt dispenser is located in the lower part of the dishwasher (see Description) and should be filled: • When the LOW RINSE AID indicator light in the control panel is lit *; • When the green float* on the cap of the salt dispenser is no longer visible. Only the first time you do this: fill the water dispenser up to the edge. Position the funnel (see figure) and fill the salt container right up to its edge (approximately 1 kg); it is not unusual for a little water to leak out. Remove the funnel and wipe any salt residue away from the opening; rinse the cap under running water and then screw it on. It is advisable to perform this procedure every time you add salt to the container. ) If the rack is equipped with a Lift-Up device* (see figure), lift it up by holding its sides. To restore the lower position, press the levers (A) at the sides of the rack and follow the rack down. € Parts in synthetic material which do not withstand high temperatures. The colours of glass decorations and aluminium/silver pieces can change and fade during the washing process. Tips: • Only use glasses and porcelain guaranteed by the manufacturer as dishwasher safe. € Collect glasses and cutlery from the dishwasher as soon as the wash cycle is over. 12 Detergent and dishwasher use Measuring out the detergent Good washing results also depend on the correct amount of detergent being used. Exceeding the stated amount does not result in a more effective wash and increases environmental pollution. In the case of normally soiled items, use approximately either 25g (powder detergent) or 25ml (liquid detergent). If the crockery is only lightly soiled or if it has been rinsed with water before being placed in the dishwasher, reduce the amount of detergent used accordingly. For good washing results also follow the instructions shown on the detergent box. [. . . ] It is therefore recommended that you check the arms from time to time and clean them with a small non-metallic brush. To remove the upper spray arm, turn the plastic locking ring in an anti-clockwise direction. The upper spray arm should be replaced so that the side with the greater number of holes is facing upwards. Cleaning the spray arms C 1 A 3 The lower spray arm can be removed by pressing on the side tabs and pulling it upwards. [. . . ]