User manual HOTPOINT LSPB 7M116 X EU

[. . . ] Read the instructions carefully, as they include important information on safe installation, use and maintenance. This appliance was designed for domestic use or similar applications, for example: - farmhouses; - use by guests in hotels, motels and other residential settings; - bed & breakfasts. Remove the appliance from all packaging and make sure it was not damaged during transportation. If it was damaged, contact the retailer and do not proceed any further with the installation process. [. . . ] 22 Refined Salt and Rinse Aid Only use products which have been specifically designed for dishwashers. If you are using a multi-function product, we recommend that you add salt in any case, especially if the water is hard or very hard. ) If you do not add salt or rinse aid, the LOW SALT* and LOW RINSE AID* indicator lights will remain lit. The use of salt prevents the formation of LIMESCALE on the dishes and on the machine's functional components. The salt dispenser is located in the lower part of the dishwasher (see Description) and should be filled: • When the LOW RINSE AID indicator light in the control panel is lit *; • When the green float* on the cap of the salt dispenser is no longer visible. Only the first time you do this: fill the water dispenser up to the edge. Position the funnel (see figure) and fill the salt container right up to its edge (approximately 1 kg); it is not unusual for a little water to leak out. € Switch it off using the On/Off button • Hold down the START/PAUSE button • Switch it on using the On/Off button • The salt indicator light flashes (as many times as the current selection. ) • Set the knob to the desired hardness level number (see Table on water hardness. ) • Switch it off using the On/Off button • Setting is complete!23 Loading the racks EN Tips Before loading the racks, remove all food residues from the crockery and empty liquids from glasses and containers. € Collect glasses and cutlery from the dishwasher as soon as the wash cycle is over. 25 Detergent and dishwasher use EN Measuring out the detergent Good washing results also depend on the correct amount of detergent being used. Exceeding the stated amount does not result in a more effective wash and increases environmental pollution. In the case of normally soiled items, use approximately either 25g (powder detergent) or 25ml (liquid detergent). If the crockery is only lightly soiled or if it has been rinsed with water before being placed in the dishwasher, reduce the amount of detergent used accordingly. For good washing results also follow the instructions shown on the detergent box. Open the detergent dispenser using button D and measure out the detergent according to the Table of wash cycles: • powder or liquid: compartments A (wash detergent) and B (prewash detergent) • tablets: when the cycle requires 1 tablet, place it in compartment A and close cover C; when it requires 2 tablets, place the second tablet on the bottom of the appliance. Remove detergent residues from the edges of the compartment and close cover C until it clicks. The detergent dispenser automatically opens up at the right time according to the wash cycle. If all-in-one detergents are used, we recommend using the TABS option, because it adjusts the cycle so that the best washing and drying results are always achieved. Only use detergent which has been specifically designed for dishwashers. [. . . ] It is therefore recommended that you check the arms from time to time and clean them with a small non-metallic brush. To remove the upper spray arm, turn the plastic locking ring in an anti-clockwise direction. The upper spray arm should be replaced so that the side with the greater number of holes is facing upwards. Cleaning the spray arms C 1 A 3 The lower spray arm can be removed by pressing on the side tabs and pulling it upwards. [. . . ]