User manual HOTPOINT LSFF 9H124 CX EU

[. . . ] This appliance was designed for domestic use or similar applications, for example: - farmhouses; - use by guests in hotels, motels and other residential settings; - bed & breakfasts. Remove the appliance from all packaging and make sure it was not damaged during transportation. If it was damaged, contact the retailer and do not proceed any further with the installation process. € The appliance was designed for domestic use inside the home and is not intended for commercial or industrial use. [. . . ] The rinse aid dispenser should be filled: • When the LOW RINSE AID indicator light on the panel/display is lit *; • When the dark optical indicator on the dispenser door “E” becomes transparent. Open the dispenser by turning the cap "G" in an anticlockwise direction. Pour in the rinse aid, making sure it does not overflow from the dispenser. Measuring out the rinse aid Adjusting the amount of rinse aid If you are not completely satisfied with the drying results, you can adjust the quantity of rinse aid used. € If there are drops of water or limescale marks on the dishes, set a high number (3-4). Setting the water hardness For perfect water softener operation, it is essential that the adjustment be based on the water hardness in your house. Very soiled dishes and pans should be placed in the lower rack because in this sector the water sprays are stronger and allow a higher washing performance. They can be used in a vertical position when arranging dishes or in a horizontal position (lower) to load pans and salad bowls easily. Some models are equipped with Vertical Zone, special pull-out supports*in the rear of the rack that can be used to support frying pans and baking pans in a more vertical position, thus taking up less space. In order to use it, just get hold of the coloured grip and pull it upwards while rotating it forward. The supports can slide right and left to fit the size of the crockery. If all-in-one detergents are used, we recommend using the TABS option, because it adjusts the cycle so that the best washing and drying results are always achieved. Only use detergent which has been specifically designed for dishwashers. Using excessive detergent may result in foam residues remaining in the machine after the cycle has ended. To achieve the best washing and drying results, the combined use of detergent, rinse aid liquid and refined salt is required. We recommend using detergents that do not contain phosphates or chlorine, as these products are harmful to the environment. Open the door and pour in a suitable amount of detergent (see Measuring out the detergent. Select the wash cycle in accordance with the type of crockery and its soil level (see Table of wash cycles) by pressing the P button. Press the Start/Pause button to start the cycle (fixed light): a long beep signals the start of the wash cycle, the cycle indicator lights up and the display shows the cycle number and the time remaining until the end of the cycle. Two short beeps and one long beep indicate the end of the wash cycle, the Start/Pause button switches off and the word END appears on the display. - The machine will switch off automatically during long periods of inactivity in order to minimise electricity consumption. AUTO WASH CYCLES*: some models of dishwasher are equipped with a special sensor which can be used to assess the level of soiling and automatically select the most efficient and economic wash cycle accordingly. [. . . ] It is therefore recommended that you check the arms from time to time and clean them with a small non-metallic brush. To remove the upper spray arm, turn the plastic locking ring in an anti-clockwise direction. The upper spray arm should be replaced so that the side with the greater number of holes is facing upwards. Cleaning the spray arms C 1 A 3 The lower spray arm can be removed by pressing on the side tabs and pulling it upwards. [. . . ]