User manual HOTPOINT LFF 8S112 X AG

[. . . ] Instructions for use DISHWASHER EN English, 1 ES Español, 15 PT Português, 29 Contents Product Fiche, 2 Precautions and advice, 3 General safety Disposal Saving energy and respecting the environment IT Italiano, 43 Installation and Assistance, 4-5 Positioning and levelling Connecting the electricity and water supplies Advice regarding the first wash cycle Technical data Assistance Description of the appliance, 6 Overall view Control panel LFF 8S112 Loading the racks, 7-8 Lower rack Upper rack Adjusting the upper rack Third rack Unsuitable crockery Damage to glass and crockery Start-up and use, 9 Wash cycles, 10 Table of wash cycles Starting the dishwasher Measuring out the detergent Special wash cycles and options, 11 Rinse aid and refined salt, 12 Measuring out the rinse aid Measuring out the refined salt Care and maintenance, 13 Cutting off the water and electricity supplies Cleaning the dishwasher Preventing unpleasant odours Cleaning the sprayer arms Cleaning the water inlet filter Cleaning the filters Leaving the machine unused for extended periods Troubleshooting, 14 Product Fiche EN Product Fiche Brand Model Rated capacity in standard place settings (1) Energy efficiency class on a scale from A+++ (low consumption) to D (high consumption) Energy consumption per year in kWh (2) Energy consumption of the standard cleaning cycle in kWh Power consumption of the off-mode in W Power consumption of the left-on mode in W Water consumption per year in litres (3) Drying efficacy class on a scale from G (low efficacy) to A (high efficacy) Programme time for standard cleaning cycle in minutes The duration of the left-on mode in minutes Noise in dB(A) Re 1pW Built-in model ARISTON LFF 8S112 15 A+ 302. 0 A 195’ 10 42 No NOTES 1) The information on the label and fiche relates to the standard cleaning cycle, this programme is suitable to clean normally soiled tableware and it is the most efficient programme in terms of combined energy and water consumption. 2) Based on 280 standard cleaning cycles using cold water fill and the consumption of the low power modes. 2 Precautions and advice This appliance was designed and manufactured in compliance with international safety standards The following information has been provided for safety reasons and should therefore be read carefully. [. . . ] Switch off the appliance by pressing the ON/OFF button, shut off the water tap and unplug the appliance from the electricity socket. Wait for a few minutes before removing the crockery in order to avoid burns. - The machine will switch off automatically during long periods of inactivity in order to minimise electricity consumption. AUTO WASH CYCLES*:some dishwasher models are equipped with a special sensor which can be used to assess the level of soiling and automatically select the most efficient and economical wash cycle accordingly. The duration of the auto wash cycles may vary due to the operation of the sensor. Changing a wash cycle in progress If a mistake was made during the wash cycle selection process, it is possible to change the cycle provided that it has only just begun: once the wash cycle has started, switch off the machine by pressing and holding the ON/OFF/Reset button. Switch it back on using the same button and select the desired wash cycle and options. Place the amount of detergent for pre-washing directly inside the tub. When measuring out the detergent refer to the Table of wash cycles to add the proper quantity. Compartment B comprises a level showing the maximum quantity of liquid or powder detergent that can be added to each cycle. Remove detergent residues from the edges of the dispenser and close the cover until it clicks. Close the lid of the detergent dispenser by pulling it up until the closing device is secured in place. The detergent dispenser automatically opens up at the right time according to the wash cycle. If all-in-one detergents are used, we recommend using the TABS option, because it adjusts the cycle so that the best washing and drying results are always achieved. Only use detergent which has been specifically designed for dishwashers. Using excessive detergent may result in foam residue remaining in the machine after the cycle has ended. The use of tablets is only recommended for models which offer the MULTI-FUNCTIONAL TABLETS option. To achieve the best results from each washing and drying cycle, powder detergent, rinse-aid liquid and salt should be used. Adding extra crockery Press the Start/Pause button and open the door, taking care to avoid the escaping steam, and place the crockery inside the dishwasher. Press the Start/Pause button: The cycle will start again after a long beep has been emitted. If the delayed start has been set, at the end of the countdown the wash cycle will not start. Press the Start/Pause symbol to pause the machine; the wash cycle is stopped. [. . . ] The lower sprayer arm can be removed by pressing on the side tabs and pulling it upwards. After cleaning the filters, re-place the filter assembly and fix it in position correctly; this is essential for maintaining the efficient operation of the dishwasher. Leaving the machine unused for extended periods Cleaning the water inlet filter* If the water hoses are new or have not been used for an extended period of time, let the water run to make sure it is clear and free of impurities before performing the necessary connections. If this precaution is not taken, the water inlet could become blocked and damage the dishwasher. [. . . ]