User manual HOTPOINT LFD 11M121 CX EU

[. . . ] This appliance is designed for domestic use or similar applications, for example: - staff kitchen areas in shops, offices and other work environments; - farmhouses; - use by guests in hotels, motels and other residential settings; - bed & breakfasts. Disposal General safety • The appliance should not be operated by people (including children) with reduced physical, sensory or mental capacities, or by inexperienced people who are not familiar with the product, unless supervision or instructions on how to use it are provided by someone who assumes responsibility for their safety. € An adult must supervise children at all times to prevent them from playing with the appliance. € The appliance was designed for domestic use inside the home and is not intended for commercial or industrial use. [. . . ] Start the cycle by pressing the Start/Pause button: The wash indicator light comes on and the time left until the end of the cycle appears on the display. Switch off the appliance by pressing the ON/OFF button, shut off the water tap and unplug the appliance from the electricity socket. Wait for a few minutes before removing the crockery in order to avoid burns. - The machine will switch off automatically during long periods of inactivity in order to minimise electricity consumption. AUTO WASH CYCLES*:some dishwasher models are equipped with a special sensor which can be used to assess the level of soiling and automatically select the most efficient and economical wash cycle accordingly. The duration of the auto wash cycles may vary due to the operation of the sensor. Changing a wash cycle in progress If a mistake was made during the wash cycle selection process, it is possible to change the cycle provided that it has only just begun: once the wash cycle has started, switch off the machine by pressing and holding the ON/OFF/Reset button. Switch it back on using the same button and select the desired wash cycle and options. Place the amount of detergent for pre-washing directly inside the tub. When measuring out the detergent refer to the Table of wash cycles to add the proper quantity. Compartment B comprises a level showing the maximum quantity of liquid or powder detergent that can be added to each cycle. No detergent Disinfecting wash cycle suitable for washing bottles, rings and teats together with plates, cups, glasses and cutlery. 30 gr/ml - 1 Tab Disinfecting cycle for cleaning the inside of the dishwasher, to be carried out only when the dishwasher is EMPTY using specific detergents designed for dishwasher maintenance. Wash cycle Wash cycles with drying Yes Options Delayed start – Tabs – Extra Dry – Half load Delayed start – Tabs – Extra Dry Short Time – Half load Zone wash Delayed start – Tabs – Extra Dry – Half load Zone wash – Short Time Delayed start – Tabs – Half load Delayed start – Tabs – Extra Dry Short Time Approximate duration of wash cycles 3:10’ 1. Good Night Yes Delayed start – Tabs – Extra dry Delayed start – Half load 3:30’ 9. ECODESIGN REGULATION ECO wash cycle is the standard cycle to which the energy label data refers; this cycle can be used to wash crockery with a normal soil level and is the most efficient in terms of energy and water consumption for this type of crockery. To reduce consumption even further, only run the dishwasher when it is full. self clean No Delayed start 0:50’ ** Quantity of pre-washing detergent. ** Data is obtained by recording values when the appliance is operational and loaded with user crockery. 24 Special wash cycles and Options Notes: Optimum performance levels when using the “Fast" and "Express 30’” cycles can be achieved by respecting the specified number of place settings. Although it has a longer duration than other wash cycles, it uses less energy and is less harmful to the environment. Note for Test Laboratories: for information on comparative EN testing conditions, please send an email to the following address: ASSISTENZA_EN_LVS@indesitcompany. [. . . ] Preventing unpleasant odours Food residue may become encrusted onto the sprayer arms and block the holes used to spray the water. It is therefore recommended that you check the arms from time to time and clean them with a small non-metallic brush. To remove the upper sprayer arm, turn the plastic locking ring in an anti-clockwise direction. The upper sprayer arm should be replaced so that the side with the greater number of holes is facing upwards. [. . . ]