User manual HOTPOINT KIX 633 C E

[. . . ] Cleaning and user maintenance shall not be made by children without supervision. WARNING: Unattended cooking on a hob with fat or oil can be dangerous and may result in fire. NEVER try to extinguish a fire with water, but switch off the appliance and then cover flame e. WARNING: If the surface in glassceramic is cracked, switch off the appliance to avoid the possibility of electric shock. [. . . ] When the power is 7200W, if the [+] or [-] key is touched the power changes to 2800W. The sequence to finish recording the new Cooktop Power Limit is: Press at the same time the left and right end heaters [+] and [-] keys. Once this is done, new Cooktop Power Limit is recorded and there is a system reset. to finish without recording changes: If during 60 seconds there is no action, changes are not recorded and there is a system reset. Initial Light Conditions When power is initially applied to the Cooktop, the touch control conducts a calibration process for the touch keys, which requires a low level of ambient light in the area of the touch keys. If during this calibration process excessive ambient lighting is detected the User Interface displays ?FL?(Infrared Ambient Light Error) and the control calibration process is suspended. In order to rectify the process any lighting that could effect the calibration process should be switched off (e. The error will disappear when satisfactory ambient lighting is detected and the touch control calibration procedure will now complete satisfactorily. The activation of of the booster is signalled by a beep sound, and the letter ?P?appearing on the display corresponding to the selected cooking zone The booster works for max 10 minutes. Press the few moments, the icon will stop illuminating and the lock function will be removed. All the keys on the cooking zone selection wil be locked if :the cooktop is off, , if the Control Panel Lock is activated or if an error on a cooktop occurs. Switching off the hob Press the button to switch off the appliance - do not rely solely on the pan sensor. If the control panel lock has been activated, the controls will continue to be locked even after the hob is switched on again. In order to switch the hob on again, you must first remove the lock function. Use cookware made from materials which are compatible with the induction principle (ferromagnetic material). We especially recommend pans made from: cast iron, coated steel or special stainless steel adapted for induction. Overheating protection If the electronic elements overheat, the number signalizing the power level starts flashing, and the letter ?c?When the temperature has reached a suitable level, this message disappears and the hob may be used again. Safety switch The appliance has a safety switch which automatically switches the cooking zones off after they have been in operation for a certain amount of time at a particular power level. For example: the right rear hotplate is set to 5 and will switch off after 5 hours of continuous operation, while the front left hotplate is set to 2 and will switch off after 8 hours. [. . . ] When disposing of packaging material: observe local legislation so that the packaging may be reused. The European Directive 2002/96/EC relating to Waste Electrical and Electronic Equipment (WEEE) states that household appliances should not be disposed of using the normal solid urban waste cycle. Exhausted appliances should be collected separately in order to optimise the cost of re-using and recycling the materials inside the machine, while preventing potential damage to the atmosphere and to public health. The crossed-out dustbin is marked on all products to remind the owner of their obligations regarding separated waste collection. [. . . ]