User manual HOTPOINT HSLMO 66F LS X

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual HOTPOINT HSLMO 66F LS X. We hope that this HOTPOINT HSLMO 66F LS X user guide will be useful to you.


HOTPOINT HSLMO 66F LS X : Download the complete user guide (4592 Ko)

Manual abstract: user guide HOTPOINT HSLMO 66F LS X

Detailed instructions for use are in the User's Guide.

[. . . ] The instructions for use, maintenance and installation, however, remain the same. All responsibility, for any eventual inconveniences, damages or fires caused by not complying with the instructions in this manual, is declined. This appliance is intended to be used in household and similar application such as: - staff kitchen areas in shop, offices and other working environments; - farm houses; - by clients in hotels, motels and other residential type environments; - bed and breakfast type environments. It is important to conserve this booklet for consultation at any moment. [. . . ] If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid hazard. aIR VENT (for the suction versions) Connect the hood and discharge holes on the walls with a diameter equivalent to the air outlet (connection flange). Using the tubes and discharge holes on walls with smaller dimensions will cause a diminution of the suction performance and a drastic increase in noise. Use a duct with as few elbows as possible (maximum elbow angle: 90°). For this product, the rear output use is PROHIBITED for the countries within the European Community, the EFTA countries, Turkey and all the countries subject to the Directives EU 65/2014 and EU 66/2014. The company declines any responsibility whenever these regulations are Your cooker hood is ready to be used in suction version. To use the hood in filtering version the special ACCESSORY KIT must be installed. Check on the first pages of this manual if the ACCESSORY KIT is furnished or must be bought separately. Note: If furnished, in certain cases, the additional activated carbon filtering system may be installed on the hood. Information about the conversion of the hood from suction version to filtering version is present in this manual. Ducting version In this case the fumes are conveyed outside of the building by means of a special pipe connected with the connection ring located on top of the hood. Diameter of the exhausting pipe must be equal to that of the connection ring. If the hood is supplied with active charcoal filter, then it must be removed. Filter version The aspirated air will be degreased and deodorised before being fed back into the room. In order to use the hood in this version, you have to install a system of additional filtering based on activated charcoal. The self-supporting metal filter does not include a support grill, in order to remove the filter ­ pull the release springs backwards and slide the filter downwards. Cleaning Clean using ONLY a cloth dampened with neutral liquid detergent. If situated inside the support grill, it may be one of the following types: Paper filter must be replaced once a month or if colouring appears on upper side, in such cases the colouring is evident through the grill openings. Metallic filter must be cleaned once a month, with non abrasive detergents, by hand or in dishwasher on low temperature and short cycle. When washed in a dishwasher, the grease filter may discolour slightly, but this does not affect its filtering capacity. [. . . ] Clean the grease filter(s) when necessary to maintain a good grease filter efficiency. Use the maximum diameter of the ducting system indicated in this manual to optimize efficiency and minimize noise. mALFUNCTIONS If something appears not to be working properly, do the following simple checks before calling Technical Service: · If the hood is not working: Check that: - The power has not been disconnected. If the hood performs inefficiently: Check that: - The motor speed selected is sufficient for the amount of smoke and vapours released. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE HOTPOINT HSLMO 66F LS X




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual HOTPOINT HSLMO 66F LS X will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.