User manual HOTPOINT HSB 7M124 B EU

[. . . ] HSB 7M124 EN English Operating instructions DISHWASHER - Contents Operating instructions, 1 Precautions and advice, 2-3 Assistance, 4 Product Data, 5 Installation, 6-7 Description of the appliance, 8 Refined salt and rinse aid, 9 Loading the racks, 10-11 Detergent and dishwasher use, 12 Wash cycles, 13 Special wash cycles and options, 14 Care and maintenance, 15 Troubleshooting, 16 FR Français Mode d’emploi LAVE-VAISSELLE - Sommaire Mode d’emploi, 1 Précautions et conseils, 3-4 Service, 4 Fiche produit, 5 Installation, 17-18 Description de l’appareil, 19 Sel régénérant et Produit de rinçage, 20 Charger les paniers, 21-22 Produit de lavage et utilisation du lave-vaisselle, 23 Programmes, 24 Programmes spéciaux et Options, 25 Entretien et soin, 26 Anomalies et remèdes, 27 EN Precautions and advice This appliance was designed and manufactured in compliance with international safety standards. The following information has been provided for safety reasons and should be read carefully. If the appliance is sold, given away or moved, make sure the manual is kept with the machine. Read the instructions carefully, as they include important information on safe installation, use and maintenance. [. . . ] Upper rack Load this rack with delicate and lightweight crockery such as glasses, cups, saucers and shallow salad bowls. Very soiled dishes and pans should be placed in the lower rack because in this sector the water sprays are stronger and allow a higher washing performance. They can be used in a vertical position when arranging tea/ dessert saucers or in a lower position to load bowls and food containers. 10 Tip-up compartments with adjustable position* The side tip-up compartments can be positioned at three different heights to optimize the arrangement of crockery inside the rack. Wine glasses can be placed safely in the tip-up compartments by inserting the stem of each glass into the corresponding slots. To change the inclination, pull up the tip-up compartment, slide it slightly and position it as you wish. The upper rack can be adjusted for height based on requirements: high position to place bulky crockery in the lower rack and low position to make the most of the tip-up compartments/sectors by creating more space upwards. EN Adjusting the height of the upper rack In order to make it easier to arrange the crockery, the upper rack may be moved to a higher or lower position. The height of the upper rack should be adjusted WHEN THE RACK IS EMPTY. Cutlery tray* Some dishwasher models are fitted with a sliding tray which can be used to hold serving utensils or small cups. For optimum washing performance avoid positioning bulky crockery directly below the tray. If the rack is equipped with a Lift-Up device* (see figure), lift it up by holding its sides. To restore the lower position, press the levers (A) at the sides of the rack and follow the rack down. € Parts in synthetic material which do not withstand high temperatures. The colours of glass decorations and aluminium/silver pieces can change and fade during the washing process. Tips: • Only use glasses and porcelain guaranteed by the manufacturer as dishwasher safe. € Collect glasses and cutlery from the dishwasher as soon as the wash cycle is over. *Only available in selected models with different numbers and positions. Select the wash cycle by turning the WASH CYCLE Measuring out the detergent A good wash result also depends on the correct amount of detergent being used. Exceeding the stated amount does not result in a more effective wash and increases environmental pollution. Based on how soiled the items are, the amount can be adjusted to individual cases using powder or liquid detergent. In the case of normally soiled items, use approximately either 35 gr (powder detergent) or 35 ml (liquid detergent). [. . . ] Cleaning the spray arms The lower spray arm can be removed by pressing on the side tabs and pulling it upwards. After cleaning the filters, re-place the filter assembly and fix it in position correctly; this is essential for maintaining the efficient operation of the dishwasher. Leaving the machine unused for extended periods If the water hoses are new or have not been used for an extended period of time, let the water run to make sure it is clear and free of impurities before performing the necessary connections. If this precaution is not taken, the water inlet could become blocked and damage the dishwasher. [. . . ]