User manual HOTPOINT HS B10 BEB

[. . . ] • • • • • • • • • BEFORE USE Remove all adhesives , protective plastic materials and cardboard packaging. Fit the hand grip (14) to the body of the upright vacuum cleaner (12). Place the lower cord-rewinding support (17) into its housing, making sure its insertion is complete. Fit the parking brush (5) or the attachment you need (see chapter “Attachments”) into the end of the suction inlet (7) until it locks into place. [. . . ] Before you plug the appliance into an electrical outlet, we recommend unwinding the entire power cord to avoid any overheating and damage. Rotate the switch-on/power electronic control (13) clockwise to start the appliance. The Eco function (if available) allows to save 30% energy, compared with the consumption relative to max suction power, ensuring at the same time cleaning efficacy. We recommend using a low suction power on delicate surfaces to avoid any damage (e. To switch off the appliance rotate the switch-on/ power electronic control to the Off position. Unplug it from the electrical outlet and rewind the cord around the lower (17) and upper (16) supports. Park the upright vacuum cleaner in a vertical position or secure it to a wall using the special hole for wall support (15). An ordinary wall plug will be enough to secure the upright vacuum cleaner to the a bag clogged with dust/powder particles reduce the motor's suction power and can even damage it. Press the dust-compartment opening button (10) to open the dust compartment lid (8). Dispose of the dust bag in compliance with all local regulations on waste disposal. Fit a new dust bag to the intake valve (22), making sure it locks into the dust bag support. The pores of 15 en it Cleaning the washable bag (F) We recommend cleaning the washable bag when the full-bag red indicator lights up. In any case change it at least each 4 months to be always sure of the best efficiency of your appliance. Press the dust-compartment opening button (10) to open the dust compartment lid (8). Fit the dust bag to the intake valve (22), making sure it locks into the dust bag support. Use the bristle-adjustment pedal (6) to clean: Hard floors Carpets and moquette Turbo brush (I) The Turbo brush (2) is especially suitable for the indepth vacuuming of short-pile carpets and moquette as well as sucking up your pet’s fur. The rotation of the brush is operated by the upright vacuum cleaner’s suction power. Parquet brush (J) The Parquet brush (3) is suitable for vacuuming very delicate surfaces such as wooden floors. The special natural bristles enable you to use it on very delicate surfaces without any harm. Nozzle for hard floor with crevices (K) The nozzle (4) is especially designed for vacuuming hard floors with crevices. ATTACHMENTS The attachments can either be supplied as standard features (based on the model) or be purchased separately from Hotpoint-Ariston's authorised centres. Precision nozzle (L) The precision nozzle will help you vacuum corners, crevices and other difficult-to-reach spots. [. . . ] Possible causes / Solutions • • • The plug was not inserted or is not making contact. The upright vacuum cleaner comes equipped with a thermal protection device for the motor that will switch off the appliance in the event of overheating. Wait for the motor to cool down, then switch on the upright vacuum cleaner. Change the dust bag or clean the washable dust bag (depending on the model). [. . . ]