User manual HOTPOINT HNP 6.5 CM X/HA

[. . . ] Il prodotto, sia internamente che General safety information esternamente (ALMENO UNA VOLTA support surface on top of the cooking AL MESE, rispettare comunque quanto appliance and the lowest part of the espressamente indicato nelle istruzioni cooker hood must be at least: di manutenzione riportate in questo 65 cm if the hood is installed over a gas manuale). Della cappa e della sostituzione e pulizia If the installation instruction manual for di lampade correttamente montate per possibile rischio di scossa elettrica. Its electrical power supply until the installation has been completed. [. . . ] Equip the room with air intakes to prevent the hood creating suction pressure in the interior (this must not exceed 0. The manufacturer is not liable for any consequences of failure to observe these instructions. 5 CM (AN)/HA Bulb (V) Bulb draw (W) Total draw (W) Halogen 2 x 25 160 Model code HNP 6. 5S CM (AN)/HA Bulb (V) Bulb draw (W) Total draw (W) Halogen 2 x 25 195 Model code HNP 6. 6 CM (OW)/HA Bulb (V) Bulb draw (W) Total draw (W) Filter or ducted?Note: If supplied with the hood, the accessory active Instructions for transforming the hood from the ducted to the Halogen 2 x 20 210 Halogen 2 x 25 220 Model code HRP 9. 8 CM (AN)/HA Bulb (V) Halogen Bulb draw (W) Total draw (W) 2 x 25 300 35 GB The hoods are conforming to the following EC Directives: HNP 9. 5S CM (AN)/HA T1 T2 T3 T4 T5 T6 T1 Motor reset Pressing the button while the hood is in operation turns it T2 Speed 1 Pressing the button sets the hood to speed 1. After 5 a speed button (T2, T3 or T4) quits booster mode and sets the selected speed. T6 Lights ON/OFF T1 T2 T3 T4 T5 The T2 saturated, while T3 A) B) or both, accordingly (see “Maintenance T1 Motor reset Pressing the button while the hood is in operation turns it T2 Speed 1 Pressing the button sets the hood to speed 1. T5 Lights ON/OFF Hold down T4 for three seconds while the hood is on. 5S CD X/HA HPS 60 IX/HA Hold down T4 for three seconds while the hood is on. GB B T1 T2 T3 T4 T5 T6 To set the operating mode of the hood, hold down T4 for 6 seconds. After a long beep, the type of installation displays: 1 Motor ON/OFF Press the button with the hood off to set speed 1. [. . . ] Extract the guard by prising it out with a small flat head screwdriver or something similar. Use only bulbs of the same type (for details, see the technical data in the following manual). If the hood turns off during normal operation: Check that: In case of faulty operation, before contacting Technical Electrical cable If the power cable is damaged, it can be replaced by the manufacturer or his technical service, to prevent any attendant risks. [. . . ]