User manual HOTPOINT HHDC 9.7 CB X/HA

[. . . ] Do not hook the unit up to its electrical power supply until the installation has been completed. € Before cleaning or servicing the unit, disconnect it from the mains by pulling the power plug or disconnecting the main circuit breaker. € It is not intended for use by children or persons with sensory or mental disability and lack of experience or familiarity, except under the supervision or instruction of a person responsible for their safety. € NEVER use the hood as a support, unless expressly instructed to do so. [. . . ] Installation The installation procedure is illustrated in the first pages of this manual. The diameter of the exhaust tube must be equal to that of the outlet flange. When routed horizontally, the tube must be angled slightly upwards (around 10°) to enable the air to be conveyed outdoors more easily. If the hood is fitted with charcoal filters, they must first be removed. This version of the hood requires installation of an accessory active charcoal filter unit. This version requires an air deflector, a reduction adapter and the charcoal filter/s. GB Electrical hook up The mains voltage must match that given on the ratings label inside the hood itself. If the hood has a power plug, connect the hood to an easily accessible regulatory power socket. If it does not (direct connection to the mains), or the socket is not easily accessible, install a two-pole regulatory switch to enable total disconnection from the mains in case of category III overvoltage, as required by the installation regulations. Always check that the mains cable is hooked up properly and check that it operates correctly before reconnecting the hood to the mains. Air exhaust (for ducted units) Connect the hood to a duct and wall exhaust hole of a diameter equal to that of the air outlet flange. Using a smaller diameter tube and exhaust hole reduces the extraction capacity of the hood and also increases its running noise. Do not connect the hood to flues carrying combustion fumes from other equipment (boilers, chimneys, stoves, etc. Observe the instructions of the competent authorities in relation to the air exhaust. The air being exhausted may not be exhausted into a wall cavity unless the cavity in question is specifically intended for this purpose. Equip the room with air intakes to prevent the hood creating suction pressure in the interior (this must not exceed 0. The manufacturer is not liable for any consequences of failure to observe these instructions. Of exhaust tube (cm) 15/12 Please check the plate in order to verify the total absorption and the light absorption Power Halogen 25 W 2 x 25 W Voltage 230 V Cap G9 Dimensions L40xØ14 The model is in accordance with the following EU directives: • “Low voltage” Directive 2006/95/EC (12-12-2006) • “EMC” Directive 2004/108/EC (15-12-2004) UR Reference no. If you wish to use it as a filter unit, you must install the proper ACCESSORY KIT. Note: If supplied with the hood, the accessory active charcoal filter unit may already be installed. Instructions for transforming the hood from the ducted to the filter version are given in this manual (see “Filter version”). Before cleaning or servicing the unit, disconnect it from the mains by pulling the power plug or disconnecting the main circuit breaker. [. . . ] Hood configuration: To set the operating mode of the hood, hold down T5 for 6 seconds while the product is off. Icons T2 or T3 will light up to show the type of installation: T2 ventilation, T3 filtering. B Disassembly: Remove the activated-carbon filter by pressing the two front levers which secure it to the hood. Assembly: Secure the activated-carbon filter first in the back using the hood's metal tabs and then in the front by pressing the two If something does not work, make the following simple checks before contacting Technical Service: If the hood does not operate: Check that: • the unit is powered up. [. . . ]