User manual HOTPOINT FTGHL 751 D/IX/HA EE

[. . . ] Use the diameter of the cookware to choose the most appropriate burner to cook with. • GAS BURNER IGNITION enables a specific burner to be lit automatically. € SAFETY DEVICE stops the gas flow if the flame is accidentally extinguished. Before operating your new appliance please read this instruction booklet carefully. [. . . ] When the installation process is complete, check the pipe fittings for leaks using a soapy solution. Should the gas pressure used be different (or vary slightly) from the recommended pressure, a suitable pressure regulator must be fitted to the inlet pipe (in order to comply with current national regulations). The hob can only be installed above built-in ovens with a cooling ventilation system. Electrical connection Hobs equipped with a three-pole power supply cable are designed to operate with alternating current at the voltage and frequency indicated on the data plate (this is located on the lower part of the appliance). If the appliance is to be installed above a built-in electric oven, the electrical connection of the hob and the oven must be carried out separately, both for electrical safety purposes and to make extracting the oven easier. Connecting the supply cable to the mains Install a standardised plug corresponding to the load indicated on the data plate. The appliance must be directly connected to the mains using an omnipolar circuit-breaker with a minimum contact opening of 3 mm installed between the appliance and the mains. The circuit-breaker must be suitable for the charge indicated and must comply with current electrical regulations (the earthing wire must not be interrupted by the circuit-breaker). The supply cable must not come into contact with surfaces with temperatures higher than 50°C. The installer must ensure that the correct electrical connection has been made and that it is compliant with safety regulations. Before connecting to the power supply, make sure that: • the appliance is earthed and the plug is compliant with the law. € the socket can withstand the maximum power of the appliance, which is indicated on the data plate. € the voltage is in the range between the values indicated on the data plate. If the socket is incompatible with the plug, ask an authorised technician to replace it. Once the appliance has been installed, the power supply cable and the electrical socket must be easily accessible. The cable must be checked regularly and replaced by authorised technicians only (see Assistance). The manufacturer declines any liability should these safety measures not be observed. Standard EN 30-2-1 Gas connection The appliance should be connected to the main gas supply in compliance with current national regulations. Before carrying out the connection, make sure the cooker is compatible with the gas supply you wish to use: G2020mbar (Natural Gas). Gas burners Each burner can be adjusted to one of the following settings using the corresponding control knob: ● Off Maximum • Pan handles should be positioned in line with one of the support bars on the pan support grid. € Pan handle should be positioned so not to protrude beyond the front edge of the hob. The more variable aspect in terms of pan stability can often be the pan itself, (or the positioning of that pan during use). [. . . ] € Stainless steel surfaces may be stained by calcareous water or aggressive detergents if left in contact for too long. € Clean with warm water and neutral detergent, and then dry with a soft cloth or chamois. Remove baked-on dirt with specific cleaners for stainless steel surfaces. € Do not leave acid or alkaline substances, such as vinegar, mustard, salt, sugar or lemon juice on the hob. [. . . ]