User manual HOTPOINT FRIO 632 CP B.S

[. . . ] € WARNING: The appliance and its accessible parts become hot during use. € Children less than 8 years of age shall be kept away unless continuously supervised. € This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Cleaning and user maintenance shall not be made by children without supervision. [. . . ] While the booster for one of the cooking zones is active, the corresponding front or rear cooking zone will operate at a reduced power level (e. If the booster for the rear left-hand hotplate has been activated, the power level of the front left-hand hotplate will be reduced). For further information, please refer to the Technical description of the models. Switching off the hob Press the button to switch off the appliance - do not rely solely on the pan sensor. If the control panel lock has been activated, the controls will continue to be locked even after the hob is switched on again. In order to switch the hob on again, you must first remove the lock function. €Demo” mode It is possible to set the hob to a demonstration mode where all the controls work normally but the heating elements do not switch on. To activate the “demo” mode the hob must be switched on, with all the hotplates switched off. When the 6 seconds have elapsed, the ON/OFF and CONTROLS LOCKED indicator lights will flash for one second. At step 2, press the button: the duration decreases progressively until it reaches 0 and switches off. Buttons and press the button; • The display will show the text DE and MO and the hob will be switched off. € When the hob is switched on again it will be set to the “demo” mode. The display will show the text DE and OF and the hob will be switched off. 15 GB The FlexiZONE mode The FLEXI Zone can be used to set the power of two „interconnected” hotplates to the same level. It can be activated if the two hotplates are OFF, by pressing the FLEXI ZONE button The FLEXI ZONE can be activated while the hob is on by pressing the FLEXI ZONE button once; the LEDs corresponding to both linked hotplates light up. The 2 LEDs remain lit as long as the hotplates are linked (if FLEXI ZONE button is pressed again, the hotplates are disconnected and are both set to power level 0). Pressing the +, - or Max buttons for one of the two Flexi hotplates also affects the display corresponding to the other hotplate. A timer may be set for the FLEXI zone; this appears on the display and both LEDs corresponding to the linked hotplates light up. When the Timer button is pressed, the two linked hotplates are treated as if they were a single zone. Selecting and using FLEXI ZONE To begin using the FLEXI ZONE, press the To set the power level (see above). Low-flame cooking FLEXI ZONE operation Once you have selected FLEXI ZONE by pressing the button , the 2 LEDs corresponding to the FLEXI ZONE for both hotplates light up; it will then be possible to control both as if they were a single zone. If only the upper or lower part is in use, the display corresponding to the unused zone will begin to flash, and after 3 minutes cooking will automatically revert to standard mode (not FLEXI). [. . . ] Disposal • When disposing of packaging material: observe local legislation so that the packaging may be reused. € The European Directive 2002/96/EC relating to Waste Electrical and Electronic Equipment (WEEE) states that household appliances should not be disposed of using the normal solid urban waste cycle. Exhausted appliances should be collected separately in order to optimise the cost of re-using and recycling the materials inside the machine, while preventing potential damage to the atmosphere and to public health. The crossed-out dustbin is marked on all products to remind the owner of their obligations regarding separated waste collection. [. . . ]