User manual HOTPOINT FD 97 C.1/E

[. . . ] Congratulations on choosing an Ariston appliance, which you will find is dependable and easy to use. We recommend that you read the instructions in this owner’s manual carefully before use for the best performance and to extend the life of your appliance, as it will provide you with all the instructions you require to ensure its safe installation, use and maintenance. Always keep this owner’s manual close to hand since you may need to refer to it in the future. Oven Light Clock adjustment Timer adjustment End cooking time Cooking time Setting confirmation Timer indicator Pre-heating (m flashing) or cooking (m on) under way indicator 9. [. . . ] The temperature and the time set previously will be displayed alternately. Press button 4 and then adjust the end cooking time by turning knob C. Press the OK button to store the setting and the display will remind you of the end cooking time and of the temperature set alternately. And a cooking time of 1 hour and 15 minutes and 12:20 as the end cooking time are programmed. Programming the end cooking time Press button 4 and then adjust by turning knob C. If the grease spots and dirt are particularly tough to remove, use a special product for oven cleaning, following the instructions provided on the packet. €¢ if you use your oven for an extended period of time, condensation may form. €¢ there is a rubber seal surrounding the oven opening which guarantees its perfect functioning. If necessary, clean it and avoid using abrasive products or objects to do so. Should it become damaged, please contact your nearest After-sales Service Centre. €¢ never line the oven bottom with aluminium foil, as the consequent accumulation of heat could compromise the cooking and even damage the enamel. €¢ clean the glass door using non-abrasive products or sponges and dry it with a soft cloth. How to remove the oven door For a more thorough clean, you can remove the oven door. Proceed as follows: • • open the door fully; lift up and turn the small levers situated on the two hinges; • grip the door on the two external sides, shut it slowly but not completely; • pull the door towards you, pulling it out of its seat; Reassemble the door by following the above procedures backwards. 1 2 3 Replacing the Oven Lamp • Disconnect the oven from the power supply by means of the omnipolar switch used to connect the appliance to the electrical mains; or unplug the appliance if the plug is accessible; • Remove the glass cover of the lamp-holder; • Remove the lamp and replace with a lamp resistant to high temperatures (300°C) with the following characteristics: - Voltage: 230/240 V - Wattage 25W - Type E14 • Replace the glass cover and reconnect the oven to the mains power supply. Practical Cooking Advice The oven offers a wide range of alternatives which allow you to cook any type of food in the best possible way. With time you will learn to make the best use of this versatile cooking appliance and the following directions are only a guideline which may be varied according to your own personal experience. Cooking on More Than One Rack If you have to cook food using several racks, use either bottom). Some examples are included in the “Practical Cooking Advice” table. When cooking other food on several racks, use the “Multi-cooking” mode b keeping the following suggestions in mind: • The oven is fitted with 5 racks. During fan assisted cooking, use two of the three central racks; the lowest and highest racks receive the hot air directly and therefore delicate foodstuffs could be burnt on these racks. €¢ As a general rule, use the 2nd and 4th rack from the bottom, placing the foodstuffs that require greater heat on the 2nd rack from the bottom. [. . . ] In particular, if the cabinet side panel: • is 20 mm thick: the removable part of the tab must be removed (Fig. A); • is 18 mm thick: use the first groove, which is factoryset (Fig. C To fasten the oven to the cabinet, open the door of the oven and attach it by inserting the 4 wooden screws into the 4 holes located on the perimeter of the frame. 24 mm In order to ensure adequate ventilation, the back panel of the cabinet unit must be removed. [. . . ]