User manual HOTPOINT FB G IX/HA

[. . . ] 12 Operating Instructions OVEN Contents IT Italiano, 1 GB English, 13 FR Français, 24 Installation, 14-17 Positioning Electrical connection Gas connection Data plate Overall view Control panel GB ES Espanol, 35 PT Portuges, 46 Description of the appliance, 18 Start-up and use, 19-20 Starting the oven How to use the timer Burner and nozzle specifications Cooking modes, 21 FZ G /HA FZ G IX /HA FB G /HA FB G IX /HA FR G /HA FR G IX /HA FR G0 /HA FR G0 IX /HA Cooking modes Practical cooking advice Cooking advice table Precautions and tips, 22 General safety Disposal Respecting and conserving the environment Maintenance and care, 23 Switching the appliance off Cleaning the appliance Cleaning the oven door Replacing the light bulb Assistance Installation GB  Before operating your new appliance please read this instruction manual carefully. It contains important information for safe use, installation and care of the appliance. The system can also provide the air needed for combustion indirectly, i. From adjacent rooms fitted with air circulation tubes as described above. [. . . ] The two appliances should be connected separately, and each one should have its own stop tap in order to make them completely independent from one another (see figures). Unscrew the oven burner nozzle using the special socket spanner for the nozzles, or better still a 7 mm socket spanner, and replace it with a nozzle suited to the new type of gas (see Table 1). Replace all the parts, following the steps described above in the reverse order.  Take particular care when handling the spark plug wires and the thermocouple pipes. • Primary air regulation for the oven burner The burner was designed not to need any adjustments to the primary air. Turn the knob first to the Max setting for about 10 minutes and then to Min. Adjust the screw located outside the thermostat cock pin until the flame is small but steady (the flame can be seen through the slots on the oven bottom). Make sure the burner does not switch off when you turn the knob from Max to Min quickly, or when you open and close the oven door quickly.  If the appliance is connected to liquid gas, the regulation screw must be fastened as tightly as possible.  Once this procedure is finished, replace the old rating sticker with one indicating the new type of gas used.  If the gas pressure is different from the recommended pressure, a suitable pressure regulator must be fitted to the inlet pipe in accordance with current National Regulations. 5 cm 58 l see data plate see data plate This appliance conforms to the following European Economic Community directives: 2006/95/EEC dated 12/12/06 (Low Voltage) and subsequent amendments - 89/336/EEC dated 03/05/89 (Electromagnetic compatibility) and subsequent amendments - 93/68/EEC dated 22/07/93 and subsequent amendments. 2002/96/EC 17 Description of the appliance GB Overall view Control panel GUIDES for the sliding racks position 5 position 4 position 3 position 2 position 1 GRILL DRIPPING PAN Control panel GRILL indicator light 0 0 1 Min TIMER knob 45 Max 220 180 150 15 30 OVEN/GRILL knob OVEN LIGHT button 18 Start-up and use  The first time you use your appliance, heat the empty oven with its door closed at its maximum temperature for at least half an hour. Ensure that the room is well ventilated before switching the oven off and opening the oven door. The appliance may produce a slightly unpleasant odour caused by the burning away of protective substances used during the manufacturing process. Switching the oven on manually In the event of a power failure, the oven burner can be lit manually: 1. Hold a match or lighter near the burner hole as shown in the figure, press knob F (see figure) in fully and turn it anticlockwise, setting it to the Max position. GB Starting the oven This knob is used not only to select the different oven modes, but also to choose the right cooking temperature for various foods from among the temperatures shown on the knob itself (the range is from 140°C to 240°C inclusive). The electronic ignition device of the oven is built into the control knob. To light the oven burner, press the OVEN knob in as far as possible and turn it anti-clockwise, setting it to position  (keeping the oven door shut). After lighting the burner allow the gas to circulate until the safety thermocouple is heated by keeping the OVEN knob pressed in for about 6 seconds.  The electronic ignition device of the oven burner must not be activated for more than 15 seconds. [. . . ] • Never carry out any cleaning or maintenance work without having unplugged the plug from the mains. Disposal • When disposing of packaging material: observe local legislation so that the packaging may be reused. • The European Directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE), requires that old household electrical appliances must not be disposed of in the normal unsorted municipal waste stream. Old appliances must be collected separately in order to optimise the recovery and recycling of the materials they contain and reduce the impact on human health and the environment. [. . . ]