User manual HOTPOINT ENXTM 18211 F

[. . . ] The compressor and condenser give off heat and require good ventilation to operate correctly and save energy. Leave a space of at least 10 cm between the top part of the appliance and any furniture above it, and at least 5 cm between the sides and any furniture/side walls. Ensure the appliance is away from any sources of heat (direct sunlight, electric stove, etc. In order to maintain the correct distance between the appliance and the wall behind it, fit the spacers supplied in the installation kit, following the instructions provided. [. . . ] Open the humidity regulator (position B) if you want to store food in a less humid environment like vegetable, or close it (position A) to store food in a more humid environment like fruit. A B ICE DEVICE* After pouring water in the special ice cups, place them in their places in the ice device. In order to get the ice cubes, it will be sufficient to turn the two buttons to the right. Before starting the appliance, follow the installation instructions (see Installation). Before connecting the appliance, clean the compartments and accessories well with lukewarm water and bicarbonate. The appliance comes with a motor protection control system which makes the compressor start approximately 8 minutes after being switched on. The compressor also starts each time the power supply is cut off whether voluntarily or involuntarily (blackout). Insert the plug into the socket and ensure that the internal light Starting the appliance Food Care Zone * Area dedicated to the storage of fresh food, such as meat and fish. Thanks to the low temperature inside the compartment, the Food Care Zone extends the period of time for which the food can be stored, keeping it fresh for up to a week. 15 GB “FOOD CARE ZONE 0°C”/ Safe Defrost*: In the “FOOD CARE ZONE 0°C” compartment there are lower temperatures than in the fridge. You can also store milk, dairy products, fresh pasta, cooked food or leftovers. € The back of the appliance may collect dust which can be removed by delicately using the hose of a vacuum cleaner set on medium power. The appliance must be switched off and the plug must be pulled out before cleaning the appliance. Avoiding mould and unpleasant odours Using the freezer to its full potential • The appliance is manufactured with hygienic materials which are odour free. In order to maintain an odour free refrigerator and to prevent the formation of stains, food must always be covered or sealed properly. € If you want to switch the appliance off for an extended period of time, clean the inside and leave the doors open. Replacing the light bulb * To replace the light bulb in the refrigerator compartment, pull out the plug from the electrical socket. Access the light bulb by removing the cover as indicated in the diagram. Replace it with a similar light bulb within the power range indicated on the cover. 16 collected separately in order to optimise the recovery and recycling of the materials they contain and reduce the impact on human health and the environment. The crossed out “wheeled bin” symbol on the product reminds you of your obligation, that when you dispose of the appliance it must be separately collected. Consumers should contact their local authority or retailer for information concerning the correct disposal of their old appliance. [. . . ] € Do not touch the internal cooling elements: this could cause skin abrasions or frost/freezer burns. € When unplugging the appliance always pull the plug from the mains socket, do not pull on the cable. € Before cleaning and maintenance, always switch off the appliance and disconnect it from the electrical supply. € The appliance has not been installed on a level surface (see Installation). [. . . ]