User manual HOTPOINT EBD 20223 F

[. . . ] Assistenza Attiva 7 giorni su 7 Assistance Before calling for Assistance: • Check if the malfunction can be solved on your own (see Troubleshooting). € If after all the checks, the appliance still does not operate or the problem persists, call the nearest Service Centre Communicating: • type of malfunction • appliance model (Mod. ) • serial number (S/N) This information can be found on the data plate located on the bottom left side of the refrigerator compartment. Never call on unauthorized technicians and always refuse spare parts which are not originals. [. . . ] To deactivate the function, press and hold the Child Lock button for 2 sI-CAREnds; deactivation will be confirmed by a short beep and by the corresponding LED switching off. After transportation of the appliance, carefully place it in an upright position and wait at least 3 hours before connecting it to the electricity mains, to make sure it operates as it should. € Clean the inside of the refrigerator well using warm water and bicarbonate of soda before placing food inside it. € The appliance comes with a motor protection control system which makes the compressor start approximately 8 minutes after being switched on. The compressor also starts each time the power supply is cut off whether voluntarily or involuntarily (blackout). Check the indicator light again: if necessary, readjust it following the initial process. If large quantities of food have been added or if the refrigerator door has been opened frequently, it is normal for the indicator not to show OK. Wait at least 10 hours before adjusting the REFRIGERATOR OPERATION knob to a higher setting. Food Care Zone * Area dedicated to the storage of fresh food, such as meat and fish. Thanks to the low temperature inside the compartment, the Food Care Zone extends the period of time for which the food can be stored, keeping it fresh for up to a week. Dual led * Thanks to the powerful light it emits, the new dual LED lighting system offers a clear view of all foods, with no shadowy areas. If the LEDs need to be replaced, please contact the Technical Assistance Service. The No Frost system circulates cold air continuously to collect humidity and prevent ice and frost formation. The system maintains an optimal humidity level in the compartment, preserving the original quality of the food, preventing the food from sticking together and making defrosting a thing of the past. Do not block the aeration cells by placing food or containers in direct contact with the refrigerating back panel. Using the refrigerator to its full potential • Place only cold or lukewarm foods in the compartment, never hot foods (see Precautions and tips). € Do not store liquids in open containers: they will increase the level of humidity in the refrigerator and cause condensation to form. 22 Easy Ice * The double tub was designed to optimise space in the freezer compartment and to ensure that ice is always readily available. Furthermore, the special fastening system makes Easy Ice an extremely flexible solution, as it can be positioned in the right or left part of the top drawers. Replacing the light bulb * To replace the light bulb in the refrigerator compartment, pull out the plug from the electrical socket. Access the light bulb by removing the cover as indicated in the diagram. Replace it with a similar light bulb within the power range indicated on the cover. [. . . ] Press these buttons a second time to display the set value on the freezer display, switch off the TEMPERATURE ALARM LED and restore normal operation. € The temperature that has been set is too high (see Start-up and use). € The temperature that has been set is too low (see Start-up and use). € The SUPER FREEZE button has been pressed (rapid freezing): the yellow SUPER FREEZE light is on or flashing ( see Description). [. . . ]