User manual HOTPOINT CT NTC IW2

[. . . ] For a cold refreshing drink the reservoir may be stored full of water in the fridge. Do not overfill the reservoir and do not leave the water goes below the min level marked on the reservoir: running the with a lower level of water will cause bubbling noises as the pump will then suck in air. Only use original parts from the manufacturer to repair and service the unit. Only use Hotpoint-Ariston [Hotpoint] UV lamps and filters with the appliance, failure to do so will void the warranty. [. . . ] A8 Repeat steps a2-a7 five times (5x): this will completely flush the carbon from the new filter. B3 Once the Filter has is at 11 months after its first usage, the Filter icon will flash as a reminder, and continue to flash until the filter has been replaced as per B4 below. During this time, your machine will continue to dispense water, until B4 below has been reached. B4 After a 12 month period, both the UV Bulb and Filter must be replaced to ensure optimal water purification. Both the UV Icon and Filter Icon will alarm 20 times and flash alternately. When this occurs, no water will be dispensed, until the Filter and UV Bulb have both been replaced and the machine reset (to do this you will need to follow steps C1 to C17). MAINTENANCE This product is a high performance water machine, keeping it in good working order will provide the reassurance of truly great drinking water. The uv bulb and filter must be replaced every 12 months to ensure that your appliance is dispensing the highest quality drinking water. For the correct and effective appliance working, use only hotpoint-ariston [hotpoint] replacement kit (read service section) Unplug the Appliance from the mains before replacing the UV lamp or filter. After this procedure it’s recommended that you clean the surface with a home-use disinfecting product. C2 Remove the two screws that hold the lid in place using the screwdriver you can find in the box. Make sure the new filter you are fitting comes in a sealed bag for hygienic purposes. C12 Screw the filter head and the filter body together, making sure it is firmly tightened. C13 Fit the filter assembly with the back into the appliance as follows: 1. Insert the filter assembly back into its cradle, aligning the two male spigots with the female holes in the cradle. Push firmly until the filter sits snugly and is flush inside the cradle and with the cradle top surface. Lock the filter by closing the locking lever until it ‘clicks’ into place Rotate the red rotating lever back into the LOCK position. Fit the lid making sure the front is pushed in place first and then push the back end with the screws down to give a snug fit. C15 Re-fit the two screws that hold the lid down using the screwdriver. C9 Unscrew the filter body from the filter head by turning the base in a anti clockwise direction as per the illustration. C16 Insert the plug into the mains socket and press and hold the dispense button for 10 seconds until you hear a beep as this will reset the filter timer. 14 en If the reservoir contains water, place a cup or container under the dispense area before carrying out step C16. [. . . ] STORAGE Never store the appliance with water in the reservoir and always store it the correct way up in a dry environment. If the unit has not been used for more than 3 months it is recommended that the filter be replaced before the appliance is used. €¢ • • SAFETY • • • Only trained competent technicians should carry out repairs on the appliance. Keep them off the floor and out of reach of infants and small children. [. . . ]