User manual HOTPOINT CM HM QBG0

[. . . ] 13 en SAFETY INSTRUCTIONS IMPORTANT TO BE READ AND OBSERVED • Before using the appliance carefully read the Health and Safety, and Use/Care guides. €¢ Keep these instructions close at hand for future reference. €¢ YOUR SAFETY IMPORTANT AND SAFETY OF OTHERS IS VERY • This manual and the appliance itself provide important safety warnings, to be read and observed at all times • All safety warnings give specific details of the potential risk presented and indicate how to reduce risk of injury, damage and electric shock resulting from improper use of the appliance. €¢ Failure to observe these instructions may lead to risks. [. . . ] €¢ CAUTION: Insure that the appliance is switched off before removing it from its stand. 17 en CLEANING AND MAINTENANCE • The appliance must be disconnected from the power supply before carrying out any cleaning or maintenance operation. €¢ Before use, and specially recommended before very first use, carefully wipe the outside of the appliance to remove any dust that may have accumulated, then dry it with a soft cloth. Do not use any harsh abrasive cleaners, alkaline cleaning agents or scouring agents. €¢ Wash the accessories in warm soapy water and then dry with a dry towel. €¢ To prevent any damage to the appliance do not use harsh solvents, alkaline cleaning agents, abrasive cleansers or scouring agents of any kind when cleaning. €¢ Wash the tank using a hard brush, water and washing-up liquid, then clean it thoroughly, dry it and put it back to place. Capsule loading lever Short and long coffee buttons Used-capsules container Drip grid Espresso cup support Drip drawer Coffee maker main body Removable water tank Water tank lid Milk frother supply base Milk frother buttons Milk frother handle Milk frother jug Milk frother lid Short long coffee button (fig. J) that the tank is securely fastened in order to prevent water spill. The product turns on and the buttons flash together during the heating up of the machine. When the correct temperature is reached, the buttons light stops blinking. With the appliance heated up, and without inserting any capsule, press the short coffee button (PICTURE B) and supply water for 10 seconds, then press the button again to stop. In case the coffee maker does not supply water, remove and plug the water tan checking the correct positioning. Use this procedure also in case the appliance has not been used for long time. PREPARING THE COFFEE INTRODUCTION Thank you for purchasing our product. In doing so, you have opted for an effective highperformance appliance. If the instructions on the correct use of this appliance are not observed, the manufacturer shall assume no responsibility for any resulting damage. The operating instructions may refer to different models: any difference is clearly identified. USING YOUR COFFEE MAKER PREPARING THE COFFEE MAKER Before you assemble the coffee maker, ensure that the power cord is unplugged and take care that the main body and all other parts are clean. Fit the power cord on the cable rack on the bottom of the machine based on its distance from the outlet (PICTURE A). Reinstall the tank by leaning it in place and press the top part until the complete joint. Make sure the water is greater than minimum level and enough to brew the coffee. [. . . ] Leave some water at the bottom of the frother for a few minutes and then empty and wipe clean with a cloth. If you wish, you can run a program with water, considering minimum and maximum levels, to make the cleaning easier. If you are heating milk or frothing milk continuosly, clean the jug after each use as described above. Do not use any aggressive or abrasive cleaning products, nor any sharp objects such as knives or hard brushes when cleaning. [. . . ]