User manual HOTPOINT ARGD 149 K

[. . . ] 12 Instructions for use WASHING MACHINE Contents GB English GB Installation, 14-15 Unpacking and levelling Connecting the electricity and water supplies The first wash cycle Technical data Description of the washing machine, 16-17 Control panel Display Running a wash cycle, 18 Wash cycles and functions, 19 Table of wash cycles Wash functions ARGD 149 Detergents and laundry, 20 Detergent dispenser drawer Preparing the laundry Special wash cycles Load balancing system Precautions and tips, 21 General safety Disposal Opening the porthole door manually Care and maintenance, 22 Cutting off the water or electricity supply Cleaning the washing machine Cleaning the detergent dispenser drawer Caring for the door and drum of your appliance Cleaning the pump Checking the water inlet hose Troubleshooting, 23 Service, 24 13 Installation GB  This instruction manual should be kept in a safe place for future reference. If the washing machine is sold, transferred or moved, make sure that the instruction manual remains with the machine so that the new owner is able to familiarise himself/herself with its operation and features.  Read these instructions carefully: they contain vital information relating to the safe installation and operation of the appliance. Levelling the machine correctly will provide it with stability, help to avoid vibrations and excessive noise and prevent it from shifting while it is operating. [. . . ] • Press the button again to disable the function; the indicator light will switch off.  If the selected function is not compatible with another function which has been selected previously, the indicator light corresponding to the first function selected will flash and only the second function will be activated; the indicator light corresponding to the enabled function will remain lit.  The functions may affect the recommended load value and/or the duration of the cycle. The corresponding indicator light will become green, remaining lit in a fixed manner, and the door will be locked (the DOOR LOCKED symbol will be on). During the wash cycle, the name of the phase in progress will appear on the display. Wash functions Stain removal This function is particularly useful for the removal of stubborn stains. When pouring in the bleach, be careful not to exceed the "max" level marked on the central pivot (see figure). To run the bleach cycle on its own, pour the bleach 4 into extra compartment 4, set the "Rinse" programme and activate 1 2 the "Stain removal" 3 programme. To bleach during a wash cycle, pour in the detergent and any fabric softener you wish to use, set the desired wash cycle and enable the "Stain removal" function. MAX Extra rinse By selecting this option, the efficiency of the rinse is increased and optimal detergent removal is guaranteed. , , and “Pump out” Easy iron By selecting this function, the wash and spin cycles will be modified in order to reduce the formation of creases. At the end of the cycle the washing machine will perform slow rotations of the drum; the EASY IRON and START/PAUSE indicator lights will flash (orange) and the text "END OF CYCLE" will appear on the display. To end the cycle, press the START/PAUSE button or the EASY IRON button. The "silk" wash cycle ends with the laundry being left to soak in the machine; the EASY IRON and START/PAUSE indicator lights will flash (orange) and the text "STOP WITH WATER" will appear on the display. To drain the water so that the laundry may be removed, press the START/PAUSE button or the EASY IRON button. Mini load This function is recommended for when the load of laundry is equal to half, or less than half, of the maximum recommended load (see Table of wash cycles). Prewash If this function is selected, the pre-wash cycle will run; this is useful for removing stubborn stains. , and “Pump out” 19 Detergents and laundry GB Detergent dispenser drawer Good washing results also depend on the correct dose of detergent: adding too much detergent will not necessarily result in a more efficient wash, and may in fact cause build up on the inside of your appliance and contribute to environmental pollution. Special wash cycles Mix 30’: this wash cycle was designed to wash lightly soiled garments quickly: it lasts just 30 minutes and therefore saves both energy and time. By selecting this wash cycle ( at 30°C), it is possible to wash different fabrics together (except for wool and silk items), with a maximum load of 3 kg. Mix 15’: this wash cycle was designed to wash lightly soiled garments quickly: it lasts just 15 minutes and therefore saves both energy and time. By selecting this wash cycle ( at 30°C), it is possible to wash different fabrics together (except for wool and silk items), with a maximum load of 1. [. . . ] Cleaning the detergent dispenser drawer 1 Remove the dispenser by raising it and pulling it out (see figure). Wash it under running water; this operation should be repeated frequently. 2 Caring for the door and drum of your appliance • Always leave the porthole door ajar in order to prevent unpleasant odours from forming. Cleaning the pump The washing machine is fitted with a self-cleaning pump which does not require any maintenance. [. . . ]