User manual HOTPOINT AQM8D 49 U H

[. . . ] Instructions for installation and use Contents Installation, 2-3 EN English, 1 WASHER-DRYER EN I Italiano, 13 Unpacking and levelling Connecting the electricity and water supplies Technical data Description of the machine, 4-5 Touch control panel How to run a wash cycle or a drying cycle, 6 Wash cycles and options, 7 Table of wash cycles Wash options Detergents and laundry, 8 AQUALTIS AQM8D 49 U H Detergent Preparing the laundry Washing recommendations Load balancing system Precautions and advice, 9 General safety Disposal Opening the porthole door manually Care and maintenance, 10 Cutting off the water and electricity supplies Cleaning the machine Cleaning the detergent dispenser drawer Caring for your appliance drum Cleaning the pump Checking the water inlet hose Trouble shooting, 11 Assistance, 12 1 Installation EN  This instruction manual should be kept in a safe place for future reference. If the washing machine is sold, given away or moved, please ensure the manual is kept with the machine, so that the new owner may benefit from the advice contained within it.  Read these instructions carefully: they contain vital information relating to the safe installation and operation of the appliance.  Inside the pack containing this manual, you will also find the guarantee and all the details necessary for installation. [. . . ] The icons corresponding to the wash cycle phases will light up during the cycle to indicate which phase is currently in progress. To change a wash cycle once it has already started, pause the washer-dryer by pressing the START/PAUSE button; then select the desired cycle and press the START/PAUSE button again. To open the door during a wash cycle, press the START/PAUSE button; if the DOOR LOCKED indicator light is switched off you may open the door. Press the START/PAUSE button again to restart the wash cycle from the point at which it was interrupted. If the START/PAUSE indicator light is flashing, press the button to end the cycle.  If you wish to cancel a cycle which has already begun, press and hold the button until the cycle stops and the machine switches off. Wash cycles and options Table of wash cycles Icon Description of the wash cycle Cottons wash cycles Cottons with pre-wash (Add detergent to the relevant compartment). Coloured Cottons (3) Jeans Special programmes Baby: heavily soiled delicate colours Mix 30': to refresh lightly soiled garments quickly (not suitable for wool, silk and clothes which require washing by hand) Durable Synthetics Silk: for garments in silk and viscose, lingerie. 90°) 40° 40° 40° 1400 1400 1400 1400 800 l l l l l l l l l l l l l - 8 8 8 8 4 (*) Note: 10 minutes after the START, the machine will recalculate the time remaining until the end of the wash cycle on the basis of the load inside it; this value will then be shown on the display. For all Test Institutes: 1) Test wash cycle in compliance with regulation EN 50229: set wash cycle with a temperature of 60°C. 2) Long wash cycle for cottons: set wash cycle with a temperature of 40°C. 3) Short wash cycle for cottons: set wash cycle with a temperature of 40°C. Wash options This option offers a high-performance wash due to the greater quantity of water used in the initial phase of the cycle, and due to the increased wash cycle duration, is particularly useful for the removal of stubborn stains. If you desire bleaching, insert the extra tray compartment (3) into 3 compartment 1. When pouring in the bleach, be 1 careful not to exceed the “max” level marked on the 2 central pivot (see figure). To bleach laundry without carrying out a full wash cycle, pour the bleach into the extra compartment 3, select the "Rinse" cycle and activate the "Super Wash" option . To end the cycle press the START/PAUSE button or the “Easy Iron” button. For the Silk wash cycle, the machine will end the cycle while the laundry is soaking and the “Easy Iron” indicator light will flash. To drain the water so that the laundry may be removed, press the START/PAUSE button or the “Easy Iron” button. Note: If you also want to run the drying cycle, this option is enabled only if combined with level “Iron”. If you select this option, the wash cycle duration will be reduced by 30%-50%, depending on the selected cycle, thereby guaranteeing simultaneous water and energy saving. Time Saver By selecting this option, the wash and spin cycles will be modified in order to reduce the formation of creases. [. . . ] • • • • The washer-dryer does not fill • • with water. ╠• • • The washer-dryer door remains locked. • If you have selected the “Baby ” cycle or the “Easy iron ” option, when the wash cycle has finished the machine will slowly rotate the drum; to end the cycle press the START/PAUSE button or the “Easy iron ” button. If you have selected the “Silk ” wash cycle, the machine will end the cycle while the laundry is soaking; to drain the water so that the laundry may be removed, press the START/PAUSE button or the “Easy iron ” button. [. . . ]