User manual HOTPOINT AQC9 2F7 TM2 1

[. . . ] Instruction booklet TUMBLE DRYER GB English, 1 Contents NL FR Français, 37 GB PT Português, 19 Installation, 2 Where to put your dryer Ventilation Electrical connection Levelling the tumble dryer Before you start using your dryer Warnings, 4 General safety Save energy and respect the environment Care and maintenance, 6 Disconnecting the power supply Cleaning the filter after each cycle Checking the drum after each cycle Empty the water container after each cycle Cleaning the Heat Pump Filter Cleaning the tumble dryer AQUALTIS AQC9 2F7 Dryer Description, 8 To open door The Features Control Panel The Display, 9 Start and Programmes, 10-15 Choosing a Programme Special Programmes Programmes Table The Controls www. Keep this instruction booklet on hand in order to refer to it when necessary. Take it with you when you move, and, should you sell this appliance or pass it on to another party, make sure that this booklet is supplied along with the dryer so that the new owner may be informed about warnings and suggestions on how the dryer works. Laundry, 16 Sorting your laundry Care labels Drying times Troubleshooting, 17 Service, 18 Spare parts Essential Contact Information Disposal of old household appliances ! [. . . ] GB Special Programmes Easy Iron Programme Easy Iron is a short 10 minute programme (8 minutes of heat followed by a 2 minutes cool tumble period) which fluffs the fibres of clothing that has been left in the same position/location for an extended period of time. Easy Iron is not a drying programme and should not be used for wet articles of clothing. These numbers refer to dry weight: Fabric: Max Cotton and Cotton mix 2. Unload the dryer immediately after the end of the drying cycle, hang, fold or iron the articles and put them away in the closet. It works very well on traditional fabrics like Cotton or Cotton mix, and less well on acrylic fibres and on materials such as Tencel. ® Wool Programme • This is a programme for tumble dryer safe garments marked with the symbol . € It can be used for load sizes up to 1 kg (approximately 3 sweaters). € Loads dried using this programme are usually ready to wear, but on some heavier garments the edges may be slightly damp. Unlike other materials, the mechanism of wool shrinkage is irreversible; i. € It can also be used on other garments made from same material such as jackets. € Loads dried using this programme are usually ready to wear; the edges or seams may be slightly damp. If this is found try turning the jeans inside out and running the programme again for a short period. € The duration of this programme will depend on the size of the load, the dryness setting selected and the spin speed used in your washer. € Use this cycle only for a 100% cotton load, do not mix dark and light coloured items. Do not use this cycle for garments with embroidery and accessories (pins, . We do not recommend that you use this programme if your jeans have elastic waist bands or embroidery. 10 Special Programmes Shirts High Heat option • This is a programme for Shirts made from Cotton. € It can be used for load sizes up to 3 kg (approximately 10 shirts). € Loads dried using this programme are usually ready to wear; the edges or seams may be slightly damp. If this is found try turning the shirts inside out and running the programme again for a short period. € The duration of this programme will depend on the size of the load, the dryness setting selected and the spin speed used inyour washer. Low Heat option • This is a programme for Shirts made from synthetic materials or a mixture of natural and synthetics materials such as Polyester and Cotton. [. . . ] Note: The gases contained in the sealed unit are not hazardous to health, but if they escape they will have an impact on global warming. Before calling the Service Centre: • Use the troubleshooting guide to see if you can solve the problem yourself (see Troubleshooting). € If not, turn off the dryer and call the Service Centre closest to you. Repairing it yourself or having a nonauthorised person try to repair it could cause harm to one or more persons and to the machine, and could invalidate the spare parts warranty. [. . . ]