User manual HOTPOINT AQ104D 49 EU/B

[. . . ] When you start your computer the Found New Hardware Wizard will appear. Next, click on Step 2: Install WinTV and select your language from the list. Ote: During the installation, other installation wizards may open, we recommend following the instructions in each of these and installing with the default options available. Ote: For advanced users you can select the 'Custom Installation' which will allow you to modify the list of applications that are installed by default. [. . . ] While in Pause mode, the Video Position bar shows the amount of the Replay Buffer which is filled with video. For example, if the Video Position indicator shows halfway, it means that half of the Replay Buffer is filled. If you find you cannot Pause as many minutes as you would like, increase the size of the Replay Buffer. While in Pause mode, the A/V stream is always saved in the Replay Buffer. WinTV-Scheduler, once it is set, can be closed, and the WinTV application will "wake up" at the desired time and tuned to the desired channel. After installation, WinTV-Scheduler can be found by going to Start / Program files / Hauppauge WinTV. Clicking the Rewind button again will continue the playing of the video. Clicking the Slow Motion button while playing video will play in Slow Motion. Clicking the Slow Motion button again, will continue playing normally. Clicking the Fast Foward button two times will fast foward your video at 8X speed. Clicking the Fast Forward button two times will fast forward your video at 8X speed. The WinTV application does not have to be active while the VTplus teletext application is running. to start the VTplus application click on the Start / All Programs / VTplus for WinTV. The items that need to be set for each event are: Source selection: leave set at WinTV to bring up the WinTV at the requested time and on the requested channel. Click on the hour to set the hour, the minute to set the minute to start the program. Ote: It is always possible that your TV show will be transmitted in advance or late, and it takes about 10 seconds to launch the WinTV and set up for recording. Please set the Time to Begin Progam few minutes before the time your TV show should starts. Program Duration: set the duration of this event, using the arrows (steps of 30 minutes) or directly the keyboard. If you select the Weekly option, select the day you would have the show recorded too. Date to End: If you have selected the Every Day or Weekly option, you can specify the date at which it will stop this task. It is therefore necessary to scan for channels first in WinTV before starting the VTplus application. It is not possible at this time to receive Digital Teletext (MHEG / BBCi) for DVB-T in the UK. [. . . ] If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: reorient or relocate the receiving antenna. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. FCC ID: H90WINTV CAUTION: Changes or modifications not expressly approved by the party responsible for compliance to the FCC Rules could void the user's authority to operate the equipment. Ote: Most WinTV functions and remote buttons are disabled when recording Record button: Set the duration of the recording, by steps of 15 minutes up to 2 hours, then by steps of 30 minutes up to 4 hours. [. . . ]