User manual HOTPOINT 641 PKL D2/HA

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual HOTPOINT 641 PKL D2/HA. We hope that this HOTPOINT 641 PKL D2/HA user guide will be useful to you.


HOTPOINT 641 PKL D2/HA : Download the complete user guide (4620 Ko)

Manual abstract: user guide HOTPOINT 641 PKL D2/HA

Detailed instructions for use are in the User's Guide.

[. . . ] мұны Пайдалану нұсқаулығы, 1 Ескертулер, 3 Көмек, 4 Құрылғы сипаттамасы, 5 Орнату, 20 Қосу және пайдалану, 24 Сақтандырулар мен кеңестер, 24 Жөндеу және күтім, 25 Ақаулықтарды жою, 26 English Operating Instructions HOB Contents Operating Instructions, 1 Warnings, 2 Assistance, 4 Description of the appliance, 5 Installation, 6 Start-up and use, 10 Precautions and tips, 10 Maintenance and care, 11 Troubleshooting, 12 Русскии Руководство по эксплуатации ВАРОЧНАЯ ПАНЕЛЬ Содержание Руководство по эксплуатации, 1 Предупреждения, 2 Сервисное обслуживание, 4 Описание из делия, 5 Установка, 13 Включение и эксплуатация, 17 Предосторожности и рекомендации, 18 Техническое обслуживание и уход, 18 Неисправности и методы их устранения, 19 Warnings WARNING: The appliance and its accessible parts become hot during use. Children less than 8 years of age shall be kept away unless continuously supervised. This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Cleaning and user maintenance shall not be made by children without supervision. [. . . ] The circuit-breaker must be suitable for the charge indicated and must comply with current electrical regulations (the earthing wire must not be interrupted by the circuit-breaker). The supply cable must not come into contact with surfaces with temperatures higher than 50°C. The installer must ensure that the correct electrical connection has been made and that it is compliant with safety regulations. Before connecting to the power supply, make sure that: • the appliance is earthed and the plug is compliant with the law. € the socket can withstand the maximum power of the appliance, which is indicated on the data plate. € the voltage is in the range between the values indicated on the data plate. If the socket is incompatible with the plug, ask an authorised technician to replace it. The internal burner has a nozzle, the external burner has two (of the same size). Replace the nozzle with models suited to the new type of gas (see table 1). Should the gas pressure used be different (or vary slightly) from the recommended pressure, a suitable pressure regulator must be fitted to the inlet pipe (in order to comply with current national regulations). DATA PLATE Electrical see data plate connections ECODESIGN This appliance conforms to the EU Regulation no. Standard EN 30-2-1 • Adjusting the burners’ primary air Does not require adjusting. Gas cooker hobs are equipped with discrete power adjustment that allows for accurately adjusting the flame to 5 different power levels. Thanks to this system, gas hobs are also capable of guaranteeing the same cooking results for each recipe, as the optimal power level for the desired type of cooking can be identified in an easier, more accurate way. Gas burners Each burner can be adjusted to one of the following settings using the corresponding control knob: ● Off Maximum Minimum To light one of the burners, hold a lit match or lighter near the burner and, at the same time, press down and turn the corresponding knob anti-clockwise to the maximum setting. Since the burner is fitted with a safety device, the knob should be pressed for approximately 2-3 seconds to allow the automatic device keeping the flame alight to heat up. When using models with an ignition button, light the desired burner pressing down the corresponding knob as far as possible and turning it anticlockwise towards the maximum setting. If a flame is accidentally extinguished, turn off the control knob and wait for at least 1 minute before trying to relight it. To switch off the burner, turn the knob in a clockwise direction until it stops (when reaches the “●” position). Discrete flame adjustment The selected burner can be adjusted - by means of the knob - to 5 different power levels. To shift between levels, simply turn the knob towards the desired power level. The selected power level is indicated by the corresponding symbol (symbols ) and, on hobs equipped with a display, by the LEDs that turn on (5 = max. [. . . ] € Clean them by hand with warm water and non-abrasive detergent, removing any food residues and checking that none of the burner openings is clogged. € When replacing the grids, make sure that the panstand area is aligned with the burner. € Models equipped with electrical ignition plugs and safety device require thorough cleaning of the plug end in order to ensure correct operation. Check these items frequently, and if necessary, clean them with a damp cloth. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE HOTPOINT 641 PKL D2/HA




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual HOTPOINT 641 PKL D2/HA will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.