User manual HOTPOINT-ARISTON HB6510

[. . . ] You will find the guarantee and other details relating to Before connecting the inlet hose to the water supply, allow the water to flow from the tap until it runs clear. Connect the inlet hose to the machine, by screwing it into the cold water inlet on the upper right hand side of the back of the machine (see figure). Once the washer-dryer has been removed from the packaging, check that it has not been damaged during transportation. If it has been damaged, contact the retailer and do not proceed any further with the installation process. [. . . ] This avoids accidental changes being made to the wash cycles, especially where children are at home. Icon lights up when the ECO indicator light: the electricity saving reaches at least 10% (this can be achieved by adjusting the wash cycle settings). When the machine is first switched on, you will be asked to choose a language (Select Language appears on the display): press the INFO button repeatedly until the required language appears on the display. After 5 seconds the language selection will be stored in the memory of the machine. If the wrong language is selected by mistake, press and hold the INFO and DELAYED START buttons simultaneously; this will return the language selection menu to the display. Running a wash cycle gB NOTE: the first time you use the washer-dryer, add detergent and run an empty 90°C cotton wash cycle without the pre-wash phase. Press the All the indicator lights will illuminate for 1 second and the text OK will appear on the display; the button will indicator light corresponding to the then remain lit in a constant manner and the START/PAUSE indicator light will flash. Load the laundry, making sure you do not exceed the maximum load value indicated by the display and in the programme table on the following page. Pull out the detergent dispenser drawer and pour the detergent into the relevant compartments as described in "Description of the machine". Turn the PROGRAMME KNOB left or right, until the required programme has been selected; the name of the programme will appear on the display. A temperature and spin speed is set for each programme; these may be adjusted. This option is not compatible with the Fastwash, Fast Spin, Pump out and Drying programmes. This option is not compatible with the Fastwash, Wool, Fast Spin, Pump out and Drying programmes. Two options are available: Press the A - Based on the damp level of the dry clothes: Iron: slightly damp clothes, easy to iron. To remove the drying cycle, press the button until the display shows the text OFF. If your laundry load to wash and dry is exceptionally in excess of the maximum load foreseen (see table of drying times), perform the wash cycle, and when the programme is complete, divide up the garments and put part of them back in the drum. : a cooling-down period is always added to the end of each drying cycle. ), its colour, the temperature of the wash, the level of soiling and the hardness of the water in the area. Measuring out the detergent carefully will avoid accidental spills and help to protect the environment: although they may be biodegradable, detergents contain elements that alter the balance of nature. We recommend: the use of powder detergents for white cotton garments and for pre-wash phases; the use of liquid detergents for delicate cotton garments and for all programmes which run at a low temperature; the use of liquid detergents for wool and silk. 0508) from The Woolmark Company, which certifies the machine washing of all woollen garments, even those whose . The Wool label states hand wash only programme therefore offers you complete peace of mind when washing all woollen garments, with great performance guaranteed every time. [. . . ] The European Directive 2002/96/EC relating to Waste Electrical and Electronic Equipment states that household appliances should not be disposed of using the normal solid urban waste cycle. Exhausted appliances should be collected separately in order to optimise the cost of re-using and recycling the materials inside the machine, while preventing potential damage to the atmosphere and to public health. Open the door; if this is still not possible, repeat the process; Replace the kick strip, making sure that the hooks are positioned in the right slots before pushing the panel towards the machine. This limits wear and tear on the machines water supply and prevents leaks. [. . . ]