User manual HOOVER WMH147

[. . . ] To ensure safety when disposing of an old washing machine disconnect the mains plug from the socket, cut the mains power cable and destroy this together with the plug. To prevent children shutting themselves in the machine break the door hinges or the door lock. If the appliance is not running properly or breaks down, switch it off, disconnect the plug from the socket, turn off the water supply and do not tamper with the appliance. Do not lean on the door when loading the machine or use the door to lift or move the machine. [. . . ] The screen will then move to the next stage and ask you if you wish to Enable Memory. This is a useful feature if you frequently wash laundry using the same programme. Selecting Enable Memory will tell the machine to remember the last programme/functions used and set them in the memory. This feature works only on the Cottons, Delicates, Synthetics and Woollens programmes. After selecting the programme and the required options (see the Wash Options section of this manual), press the Start Pausa button once to start the wash cycle. The display will indicate that the door is locked and the machine will begin to sense the wash load and ask you to wait. After the appropriate parameters have been programmed by the machine the display will indicate the approximate time until the end of the programme. This calculation is based on a full load and will be adjusted to suit the size and composition of the load as the machine progresses through the wash cycle. The programme may be paused at any time during the wash cycle by holding down the Start Pausa button for about three seconds. When the machine is in the paused mode the following display will appear: After about two minutes the display will then change to the following, which means that the door can now be opened: To cancel the programme the programme selector should be turned to the OFF position. In this mode the display will go blank because the machine is now OFF. Action required to complete the cycle To select a full spin cycle please turn the dial to the required spin programme (see Programme Guide). The machine will then pump out the water and the programme will conclude with a short spin. Finally, the programme carries out a brief tumbling action to loosen the items in the load. Press the Planchado Rapido button and the machine will pump out the water and complete the cycle with a short spin. The machine stops in the final rinse stage and the option indicators blink. The load is held in the water in the drum, thus reducing creasing and enabling easier ironing. The machine stops in the final rinse stage and the option indicators blink. The load is held in the water in the drum, thus reducing creasing and enabling easier ironing. Press the Planchado Rapido button and the machine will pump out the water to complete the cycle. The Programme Set End Time/Start Delay options can be used if you want the washing to be ready at a later time (but within 24 hours). The way these buttons function will depend on which Time Mode you have selected in the Inter@ct menu. [. . . ] If the DOOR LOCKED (PUERTA SEGURA) message is displayed and the machine does not start this means that the machine cannot fill with water, check the following: 1. Ensure that there is not a blockage in the drain hose or the hose is not kinked. If connected to the sink waste make sure you have cut the membrane or removed the bung from the under sink drainage unit. If you have found any of the above problems correct them and run the machine through a spin cycle to drain the water. [. . . ]