User manual HOOVER VACUUM

[. . . ] For further information on the treatment, recovery and recycling of this appliance, contact your competent local office, the household waste collection service or the shop where you purchased the appliance. This appliance is intended for storing food and is manufactured in conformity with European regulation (EC) No. This product has been designed, manufactured and marketed in compliance with: - the safety objectives of Low Voltage Directive 73/23/EEC; - the protection requirements of EMC Directive 89/336/EEC, amended by Directive 93/68/EEC. Electrical safety of the appliance is guaranteed only if it is connected to an efficient and approved earthing system. [. . . ] iNSTALLATION INSTRUCTIONS Before Using Your Wine Cooler Remove the exterior and interior packing , including protective foam on door panels . Check to be sure the following parts are included: 5 slide out shelves 1 wine rack 1 Instruction manual Before connecting the appliance to the power source, let it stand upright for approximately 2 hours. This will reduce the possibility of a malfunction in the cooling system from handling during transportation. Installation of Your Wine Cooler Place your appliance on a floor that is strong enough to support the appliance when it is fully loaded. To level your appliance, adjust the legs at the front of the appliance. Allow 5 inches of space between the back and sides of the appliance , which allows the proper air circulation to cool the compressor. Locate the appliance away from direct sunlight and sources of heat (stove, heater, radiator, etc. Direct sunlight may affect the acrylic coating and heat sources may increase electrical consumption. Extreme cold ambient temperatures may also cause the appliance not to perform properly. Too much moisture in the air will cause frost to form quickly on the evaporator. Plug the appliance into an exclusive properly installed-grounded wall outlet. The defrost water is channelled into a condensate drain pan which is located at the back of the wine cooler on the top of the compressor from where it evaporates. To accommodate different size bottles, they can be moved up or drown by sliding them out of the tracks. The shelves are designed to accommodate the maximum amount of bottles. Wine Rack There is an additional wine rack at bottom section of the unit where you can store up to 6 wine bottles. Once the wine cooler is running for a few hours everything will be back to normal. Also, there is a 2 to 3 C variance between the top and bottom shelves of each compartment. 6 CARE AND MAINTENANCE CAUTION: Anytime you could not unscrew the screws of the middle clapboards with display screen on it to repair the appliance. CHANGING THE LED LIGHT Note: All parts removed must be saved to do the replacement of the LED light. Before removing the LED light, either unplug the refrigerator or disconnect the electricity leading into the refrigerator at the main power supply. failure to do so could result in electrical shock or personal injury. You should use the LED light which is of the same type as the originally supplied with the appliance. [. . . ] It may also be necessary to periodically wipe the bottom part of the storage area, as the wine cooler is designed to retain humidity, and condensation may collect there. Maintenance of Your Wine Cooler Power Failure Most power failures are corrected within a few hours and should not affect the temperature of your wine cooler if you minimize the number of times the door is opened. Be sure the wine cooler stays in the upright position during transportation. 7 Troubleshooting You can solve many common wine cellar problems easily, saving you the cost of a possible service call. [. . . ]