User manual HOOVER UH70086

[. . . ] Do not pick up anything that is burning or smoking, such as cigarettes, matches, or hot ashes. WARNING: This product contains chemicals known to the State of California to cause cancer, birth defects or reproductive harm. Avoid picking up hard, sharp objects with this product, as they may cause damage. Do not use sharp objects to clean out hose as they can cause damage. [. . . ] 5 For storage mode, push dusting brush all the way up onto crevice tool. 6 Snap combination tool into tool storage area (B) on back side of vacuum. How to use Operate cleaner only at voltage specified on data plate on bottom of cleaner. 7 The handle of your cleaner has two positions: upright for storage and when using cleaning tools; operating position for general operation on carpet and floors; hold nozzle with foot (E) and pull handle back. 6 Slide the telescopic handle release down to easily adjust height of ergonomic handle Tools allow for cleaning surfaces above the floor and for reaching hard to clean areas. Crevice Tool may be used in tight spaces, corners and along edges in such places as dresser drawers, upholstered furniture, stairs and baseboards. Use Upholstery Tool to clean upholstered furniture, draperies, mattresses, clothing, and carpeted stairs. Dusting Brush may be used for carved furniture, table tops, books, lamps, lighting fixtures, venetian blinds, baseboards, shutters, and registers. 2 To remove hose for tool use, press the hose release button and pull hose end out. To lock back into place, push hose into hose tube until you hear a click. Press the hose release button on the nozzle and remove the hose from the nozzle. Check for obstructions in the brushroll area and remove any obstructions. To reduce the risk of injury from moving parts, unplug vacuum before servicing. The belt is located under the bottom plate of the vacuum and should be checked from time to time to be sure it is in good condition. Place handle in the low position and turn the cleaner over so the bottom side is up. Should the agitator become dislodged while replacing the belt, reposition it as shown. Grasp agitator firmly and fit it into position by first sliding end opposite of belt into the rectangular slot on side of cleaner. Turn the agitator making sure the belt is not pinched between agitator and agitator shield. 20 Place the bottom plate aligning the screw holes and install the 6 screws as shown. Belt: what to buy Use only genuine HOOVER® belts with your vacuum. If a minor problem occurs, it usually can be solved quite easily when the cause is found by using the checklist below. Any other servicing should be done by an authorized service representative. [. . . ] HOW TO MAKE A WARRANTY CLAIM If this product is not as warranted, take or send the product to either a Hoover® Sales and Service Center or Hoover® Authorized Warranty Service Dealer along with proof of purchase. For additional assistance or information concerning this Warranty or the availability of warranty service outlets, phone the Hoover® Consumer Response Center, Phone 1-800-944-9200, Mon-Fri 8am-7pm EST. WHAT THIS WARRANTY DOES NOT COVER This Warranty does not cover: use of the product in a commercial operation (such as maid, janitorial and equipment rental services), brushroll, belt, improper maintenance of the product, damage due to misuse, acts of God, nature, vandalism or other acts beyond the control of Hoover®, owner's acts or omissions, use outside the country in which the product was initially purchased and resales of the product by the original owner. This warranty does not cover pick up, delivery, transportation or house calls. [. . . ]