User manual HOOVER TCX52

[. . . ] Before performing any maintenance operation, isolate the hood from the electrical supply by switching off at the connector and removing the connector fuse. Or if the appliance has been connected through a plug and socket, then the plug must be removed from the socket. [. . . ] To clean the outside of the hood use a cloth moistened with denatured alcohol or neutral liquid detergents. The metal grease filter lasts forever and must be washed either by hand or in the dishwasher (65°C) with suitable detergents. Let the filter dry without damaging it before putting it back into place. Carry out the above steps in reverse order to put the filters back after having washed them. Before calling for repair service because the hood fails to light up, make sure the lamps are well inserted. Appliance without plug Fit an approved plug or an approved bipolar switch with a minimum contact opening of not less than 3mm. The manufacturers are not liable for any problems caused by the user's failure to observer the above instructions. Two systems are available: Vapours are extracted outside through an exhausting pipe that is affixed to the connection ring above the hood. The air is filtered through a carbon filter and recirculated into the room through the grid on the higher part of the chimney. If the hood is not supplied with carbon filter, then it must be ordered and mounted. [. . . ] If the hood is not supplied with carbon filter, then it must be ordered and mounted. These minimum distances between hobs and grease filter must be observed: Minimum 600 mm - electric hobs Minimum 700 mm - gas or mixed hobs Before completing any connection, make sure the house voltage corresponds with the voltage indicated on the label affixed inside the hood It is advisable to call a qualified technician to make the electrical connection. [. . . ]