User manual HOOVER TCP2010

[. . . ] Adjust the length of the telescopic tube* by moving the telescopic release button* up and raise or lower the handle to the most comfortable cleaning position [6]. Press the pedal on the nozzle [7] to select the ideal cleaning mode for the floor type. Hard Floor: The brushes are lowered to protect the floor Carpet: With lifted brushes for the deepest clean 4. Switch the cleaner on by pressing the On/Off pedal on the cleaner main body. [. . . ] Warning - The bag door will NOT close if the dust bag and/or the bag holder are not assembled to the cleaner. Always ensure the bag and bag holder are present when closing the bag door. Check if there is any other blockage in the system - Use a rod or a pole to remove any blockage from the Teletube or flexible hose. Warning - The bag check indicator will turn red if the cleaner is used when full, if there is a blockage or if the filters are dirty. If the cleaner is used for a significant period of time with the bag check indicator is red, a thermal cut out will switch the cleaner off to prevent overheating. The bag check indicator turn green once the cleaner has switched off to signal that the thermal cut out has been activated. If this should happen, switch the cleaner off, unplug and correct the fault. remember: The bag check indicator may also be red if an obstruction has occurred. In this case refer to ‘Removing A Blockage From the System’. Cleaning the Filters To maintain optimum performance of your cleaner, please wash the filters after each 5 bag changes. ACCESSORIES AND NOZZLES All accessories can be fitted to the end of the handle or the end of the tube. [23] 2 in 1 tool – Combines two functions in one, the 2 in 1 tool can be connected as a crevice tool. Pet Hair Remover Mini Turbo Nozzle* – Use the mini turbo nozzle on stairs or for deep cleaning on textile surfaces and other hard to clean areas [1T]. Allergen Remover Mini Turbo Nozzle* – Use the mini turbo nozzle on stairs or for deep cleaning on textile surfaces and other hard to clean areas. [1U] Grand Turbo Nozzle* – Use the turbo nozzle for deep cleaning on carpets. [1V] Hard Floor Caresse Nozzle*– For wooden floors and other delicate floors. [1W] IMPORTANT: Do not use the grand turbo nozzle or mini turbo nozzles on rugs with long fringes, animal hides and carpet pile deeper than 15mm. Lift the bag door release latch [13] to open the cover and remove the bag holder. To remove the pre-motor filter slide the pre-motor filter frame from the cleaner. Wash it in hand warm water, [20] and allow it to dry thoroughly before replacing to the cleaner [21]. To remove the exhaust filter, unclip the exhaust filter cover [18] and remove the filter pack. Wash the filter in hand warm water [20] and allow it to dry thoroughly before replacing to the cleaner. [. . . ] Please refer to ‘Removing a blockage from the system’ Has the cleaner overheated?If so, it will take approximately 30 minutes to automatically reset IMPORTANT INFORMATION Your Guarantee Hoover spares and Consumables Always replace parts with genuine Hoover spares. These are available from your local Hoover dealer or direct from Hoover. H64, 35600637 H63, 35600536 U63, 35601193 G130, 35601195 G131 PC, 35601196 J54, 35601197 J46, 35601116 D128, 35601194 The guarantee conditions for this appliance are as defined by our representative in the country in which it is sold. [. . . ]