User manual HOOVER T 085S

[. . . ] To ensure safety when disposing of an old washing machine disconnect the mains plug from the socket, cut the mains power cable and destroy this together with the plug. To prevent children shutting themselves in the machine break the door hinges or the door lock. If the appliance is not running properly or breaks down, switch it off, disconnect the plug from the socket, turn off the water supply and do not tamper with the appliance. Do not lean on the door when loading the machine or use the door to lift or move the machine. [. . . ] Some tablets are designed to be placed in the dispenser drawer, check the detergent pack for details. The programme selector must be returned to the ARRÊT position to reset the controls between each wash cycle. This status will be indicated by the STOP indicator light flashing, this light will continue to flash until the machine has started or the machine is returned to the ARRÊT position. After selecting the programme and the required options press the Départ/Pause button once to start the machine. The STOP light will stop flashing and DEPART light will illuminate and there will be a short time delay to the start of the programme while the machine sets the wash parameters for the selected programme and options. If the duration of the programme you have selected is shorter than 60 minutes, then the time remaining indicator will illuminate accordingly. The Porte Sécurisée indicator light will also illuminate a few seconds after pressing the Départ/Pause button. When starting a subsequent wash cycle the programme selector must be returned to ARRÊT prior to the next programme being selected and started. The programme may be paused at any time during the wash cycle by holding down the Départ/Pause button for about two seconds. when the machine is in the paused mode , the time remaining for the programme in the TEMPS RESTANT indicator and option buttons will flash. The Porte Sécurisée indicator light will remain illuminated for approximately 2 minutes. Turn the drying time selector until the indicator aligns with the drying programme or desired time. Only a maximum of 5kg of laundry can be loaded Note: If the drying time is selected before the wash cycle is completed the machine will automatically commence the drying programme. Refer to the Programme Guide to identify which drying programme will be automatically selected after the wash programme. To protect your laundry certain programmes (eg Silk) cannot be followed automatically by a drying programme. The drying time can be reduced at any time during the cycle but cannot be increased. This ranges from Extra Dry for bath towels and bathrobes, through Cupboard Dry for items that will be put away without ironing, to Iron dry that leaves the laundry suitable for ironing. Note: If you do not need to dry after the wash cycle ensure the drying selector is switched OFF ( ) The times given below are indicative and will vary with the exact level of dryness required (eg for ironing or ready to hang) and the size and composition of the load. The washing machine is fitted with a self adjusting water level system. This system enables the machine to use the optimum amount of water needed to wash and rinse the laundry in relation to the particular load. This results in a reduction of the water and electricity used without in any way compromising the washing and rinsing performance. The amount of water and electricity used will always be appropriate for the clothes load. [. . . ] If so, deselect the option and the programme will complete (see page 21 for complete explanation of the function). Ensure that the door glass and gasket are kept clean and free of laundry when loading the machine. Have you selected an option that changes the spin profile (Repassage Facile or change of spin speed on the selector)?To reduce noise and vibration and improve the machine's reliability and life, the machine is fitted with an electronic sensor that detects if the load is unbalanced. [. . . ]