User manual HOOVER SX 6254

[. . . ] When using the vacuum cleaner on stairs, always ensure that you hold the appliance steady with one hand. ⷠDo not leave the appliance unattended whilst it is switched on and ensure that children do not play around with the appliance. ⷠAlways pull out the plug ­ if the appliance malfunctions during operation ­ before cleaning and maintenance ­ after use ­ when changing the filter. [. . . ] ­ Sliding air trap closed = full suction power ­ Sliding air trap open = reduced suction power When vacuuming out containers in which the liquid level is higher than the top of the collecting bin and which have a larger volume than the capacity of the collecting bin, liquid can continue to be vacuumed beyond the capacity of the collecting bin if the float valve is closed. In such cases, vacuum only in partial amounts and intermittently empty the collecting bin. Lift the tube and flexible hose out of the liquid first and then turn off the appliance afterwards, in order to prevent an afterflow of liquid. Remove the filters from the appliance, because they will otherwise be damaged (figures C and D). Place the motor block onto the collecting bin and snap shut with snap-on fasteners. Remove the hose by turning the hose connecting piece to the side and withdrawing the hose. After completion of wet vacuuming, please clean and dry the appliance and the accessories used. If this is the case, switch off the appliance and empty the collecting bin. Thereafter, in order to prevent excess foam, put 1 /2 cup of vinegar into the collecting bin. Excess foaming will not occur after you have thoroughly cleaned the carpet once with HOOVER cleaning concentrate, because it contains a special anti-foam substance. Ensure that there is always liquid in the fresh water container when the spraying function is switched on, in order to avoid possible damage to the pump. Remove the lid of the cleaning fluid tank and fill the tank with HOOVER Cleantex Cleaning Fluid. Take the suction hose for cleaning fluid out of its holder on the motor block. Place the motor block onto the collecting bin such that the suction hose (36) is immersed all the way to the bottom of the cleaning fluid tank and is not bent. Remove the hose by turning the hose connecting piece to the side and withdrawing the hose. Snap the handle into the suction tube and fasten the cleaning fluid hose to the flexible hose by means of the plastic clips. Snap the cleaning fluid hose into the quick coupling on the motor block. Place the cleaning fluid hose of the carpet spraying nozzle onto the cut-off valve and lock it in place by turning it. [. . . ] No cleaning fluid is coming out: - Is the pump switched on (switch (7) has to light up)?If the spray nozzle becomes clogged, lay the nozzle into water for a while and then blow strongly through it. To obtain approved HOOVER service and genuine HOOVER parts, please call: Gias Customer Service 08705400600 or your nearest Hoover Service Centre. [. . . ]