User manual HOOVER STEAMVAC DUAL V CARPET CLEANER

[. . . ] Please review this manual before operating your Hoover® product. Please enter the complete model and serial numbers in the spaces provided. Verification of date of purchase may be required for warranty service of your HOOVER product. Be sure to fill out and return the product registration card included with your cleaner. [. . . ] In a small, hidden area, gently rub the surface with the dampened cloth. Wait ten minutes and check for color removal or bleed with white paper towel or cloth. When cleaning entire floor, move furniture out of area to be cleaned (may not be necessary if only high traffic areas are to be cleaned). For furniture too heavy to move, placealuminumfoilorwaxpaperunder legs. Pretreat spots and heavy traffic areas with HOOVER®Spot&StainSprayCleaner*-FollowDirectionsonbottle. To prevent staining, use plastic or aluminum foil to protect wood or metal surfaces from possible water spray. To avoid wetting and possible damage to wood floors underneath area rugs/carpet, either move area rugs/ carpet to a non-wood hard floor surface or place waterproof material (e. Fill detergent container with Hoover Carpet/UpholsteryDetergentaccordingto instructions for Figs. To avoid walking on damp carpet, start at the end of the room farthest from the door or path to sink where tanks will be emptied and filled. Squeeze trigger to apply cleaning solution and slowly push cleaner forward (equals one wet stroke). Continue to squeeze trigger and slowly pull cleaner back toward you (second wet stroke). the cleaner rinses the carpet on the backward pass (on Auto-Rinse only). Note: To assure proper rinsing, it is important to keep the cleaner on the same path backward as forward. Release trigger and slowly push cleaner forward over area just sprayed with solution (dry stroke). Then slowly pull cleaner back toward you without squeezing trigger (dry stroke). Continue using dry strokes until little water is visible passing through the recovery tank lid. Overlap strokes by 1 inch to help prevent streaking (Pass over the same area a minimum of 4 times = 2 while squeezing the trigger and 2 without). If you would like to rinse the carpet with water only, set Rinse Setting switch to RINSE (Fig. In this setting, rinsing will be done on both forward and reverse strokes. Note: To avoid saturating carpet, do not use more than 4 wet strokes over one area. For best cleaning results and to aid in faster drying of carpet, end with more dry strokes. (Continue using dry strokes until little water is visible passing through the recovery tank lid. [. . . ] Fill detergent container with HOOVER Hard Floor Cleaning Solution according to instructions for Fig. Note: If may be necessary to rotate the scrub module(K)slightlysoitwillalignproperly to the base. Use your cleaner only on upholstery marked "W" or "W/S". Fill detergent container with HOOVER Carpet/UpholsteryDetergentaccordingto instructions for Fig. [. . . ]