User manual HOOVER ST 125

[. . . ] To avoid a safety hazard, an authorised Hoover service engineer must replace the supply cord. Connect the hose to the cleaner main body, ensuring it clips and locks into position. [1] Connect the tube upper end to the navigator handle , and store the 3in1 tool underneath the handle. [. . . ] [3] Select carpet care control height by pressing the pedal in the nozzle. Unplug and press the cord rewind button to wind the power cord back into the cleaner. When the dust reaches the max level indicator in the container empty the dust container. IMPORTANT:To maintain optimum performance do not allow the dust to sit higher than the max level. Release the container carry handle by lifting the centre latch to detach the dust container from the main cleaner and pull upward to remove. [8, 9] Hold the dust container over a bin with one hand and with the other pull the dust container catch to open the door and empty. [10] Close the dust container door and refit to the cleaner main body. To lock in place push the container carry handle down until the latch connects with the main body of the cleaner. Once correctly retained the carry handle will sits flush with the top of the cleaner. Once correctly retained the carry handle will sits flush with the top of the cleaner. These are available from your local Hoover dealer or direct from Hoover. Should you require service at any time, please contact your local Hoover Service Office. Check if there is any other blockage in the system - Use a rod or pole to remove any blockage from the extension tube or flexible hose. Check if pre-motor filter is fitted and filter door is closed Check if the cyclonic unit needs to be cleaned. Safety Although safety certification of electrical appliances is not required by law in the UK, Hoover believe that independent approval is the best way of demonstrating safety in design and manufacture. The British Electrotechnical Approvals Board (BEAB), the independent UK national authority for the safety of domestic electrical appliances, ensures that European safety standards are met and maintained throughout the production life of an appliance. All appliances that pass the requirements are permitted to carry the BEAB mark of safety. quality BSI ISO 9001 Hoover's factories have been independently assessed for quality. [. . . ] Our products are made using a quality system which meets the requirements of ISO 9001 Should you have a problem with the product, complete this simple user checklist before calling your local Hoover service. The Environment: This appliance is marked according to the European Directive 2002/96/EC on waste Electrical and Electronic Equipment (WEEE). By ensuring this product is disposed of correctly you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. [. . . ]