User manual HOOVER SENSORY ECOBOX SYSTEM

[. . . ] To maintain optimum performance we recommend that you follow these simple instructions. To maintain the best performance, we would recommend that you wash the Ecobox every month removing even the finest dust retained in it. To wash and optimise the performance the following simple steps should be taken: 1 Shake out the Ecobox to remove large dirt and debris as described in "Emptying the Ecobox". Brush the inside of the Ecobox to remove the fine dust that may have formed on the walls of the container. [. . . ] Please ensure that these are fully understood before operating the appliance. Important: The wires in the power cord are coloured in accordance with the following code: Blue - Neutral Brown - Live 13 Amp fused plug on UK versions only. By following this step-by-step guide your new Sensory Ecobox system will be ready for use: · Open the top cover (A) ensuring that the Ecobox, Ecobox lid (B1), pre-motor filter (B2) and exhaust filter (B3) are fitted correctly. Insert the hose end into the top cover, ensuring it clips and locks into position (C). Fit extension tubes (E1), floor nozzle (E2), or other accessories as required for use. Hoovers unique Ecobox is made from a special porous plastic material which allows air to pass through whilst retaining most of the dirt and fine dust. Press it again to stop the cleaner before removing the plug after use. In this event extract the plug from the socket and allow cleaner to cool for 30 minutes. Check if the Ecobox needs cleaning or if there is a blockage in the system (see chapter: "Cleaning The Ecobox" and "Removing A Blockage From The System"). Adjust the suction by moving the handle valve (H): suction will decrease when opening the valve. Press pedal on the nozzle to lower the brushes when cleaning hard floors. IMPORTANT: do not use Turbo nozzle on rugs with long fringes, animal hide and over carpet piles with a depth exceeding 15 mm. Remove tool and use as: a) Crevice tool: for corners and hard to reach areas (K1). The tubes can be parked at the rear of the cleaner or stored into the storage slot underneath the cleaner. Shake the Ecobox if required or use a brush to remove any of the remaining dust or debris (P). To close the Ecobox locate the cover rear guides into the container recess then close firmly (Q). To maintain the best performance, we would recommend that you wash the Ecobox every month removing even the finest dust retained in it. To wash and optimise the performance the following simple steps should be taken: · Shake out the Ecobox to remove large dirt and debris (P) as described in "Emptying The Ecobox". Brush the inside of the Ecobox to remove the fine dust that may have formed on the walls of the Ecobox (R). Wash the inside and outside of the Ecobox thoroughly using warm water and washing up liquid. At this point if desired, the Ecobox can be placed in a dishwasher and washed on a full wash and dry cycle at up to 75°C (S). If not placed in a dishwasher rinse thoroughly inside and outside making sure no detergent is left on the Ecobox (T). [. . . ] Press pedal on the nozzle to lower the brushes when cleaning hard floors. IMPORTANT: do not use Turbo nozzle on rugs with long fringes, animal hide and over carpet piles with a depth exceeding 15 mm. Remove tool and use as: a) Crevice tool: for corners and hard to reach areas (K1). The tubes can be parked at the rear of the cleaner or stored into the storage slot underneath the cleaner. [. . . ]