User manual HOOVER R 2530

[. . . ] The use of multiple socket adapters and/or extension cables is not recommended. This fundamental safety requirement must be verified and, if there are any doubts, the installation should be thoroughly checked by a professional electrician. [. . . ] When the control value is changed the freezer cannot start up immediately because it has been halted. Temperature regulation is done using the thermostat knob to be found outside the freezer. It is recommended to keep the thermostat knob at a mid point position and to increase it by a few numbers when the freezer is opened frequently or when a lage quantity of food to be frozen is put in. On Position "q" the freezer will not operate although the green light will still be on. The red warning light (C) when lit up means that the temperature in the freezer compartment is not adequate. - The red light goes off once the freezer compartment has reached the required temperature. By turning the thermostat knob to "SUPER" the yellow light (D) will illuminate, indicating that the fast freeze has been started making the compressor work continuously. The symbol shows that frozen products can be stored for a long time and that p fresh foods can be frozen. Conservation times are closely connected with maintaining the temperature, thus any changes will affect the life of the product. In the case of a power cut do not, under any circumstances, open the door. For longer periods the food should be wrapped in special foodstuff paper and preferably put into another freezer or, at least, in a cool place. In this case it is advisable to eat the food within 24 hours or to cook it and then to refreeze it. In some models, equipped with cool packs, in case of interruption in power the temperature is kept low for a longer period of time, keeping the frozen foods at the right temperature. For the standard refrigeration tests, we recommend that you remove all the baskets, apart from the last two. [. . . ] If your freezer does not work, or if it does not work properly, check these points before making a Service call. 4) Have you let too much frost accumulate on the evaporator (more than 4 to 5 mm)? [. . . ]