User manual HOOVER NEXTRA

[. . . ] Please read and follow these instructions carefully and operate the machine accordingly. This booklet provides important guidelines for safe use, installation, maintenance and some useful advice for best results when using your machine. Keep all documentation in a safe place for future reference or for any future owners. Please check that the following items are delivered with the appliance: Instruction manual Guarantee card Blanking plug Inlet hose & hooked end support (see Unpacking and Installation Instructions) Base panel & x2 push clips Energy Label Your local council will be able to give you details of current means of disposal. [. . . ] when the machine is in the paused mode , the time remaining for the programme in the CHRONOVISION indicator and option buttons will flash. The indicator light will remain illuminated for approximately 2 minutes. The indicator light is illuminated when the door is fully closed and the machine is ON. When is pressed on the machine with the door closed the indicator will flash momentarily and then illuminate. A special safety device prevents the door from being opened immediately after the end of the cycle. Wait for 2 minutes after the wash cycle has finished and the light has gone out before opening the door. As a safety measure, check that there is no water evident in the drum. Fast Iron Function Programme is completed by a short, very low spin speed. The machine stops in the final rinse stage and the option indicators blink. The load is held in the water in the drum, thus reducing creasing and enabling easier ironing. The machine will then pump out the remaining water and the programme will conclude with a short spin. Finally, the programme carries out a brief tumbling action to loosen the items in the load. Press the button and the machine will pump out the water and complete the cycle with a short spin cycle. The machine stops in the final rinse stage and the option indicators blink. The load is held in the water in the drum, thus reducing creasing and enabling easier ironing. The machine stops in the final rinse stage and the option indicators blink. The load is held in the water in the drum, thus reducing creasing and enabling easier ironing. Press the button and the machine will pump out the water to complete the cycle. The washing machine is equipped with a temperature selector knob to set the temperature you require. Bigger energy savings can be achieved by using the lower temperature settings around the dial between and 40°C. By selecting the position, the wash temperature is limited to the water inlet temperature, thus reducing energy consumption further. We recommend that the temperature shown on wash care garments should never be exceeded. [. . . ] If so, deselect the option and the programme will complete (see page 21 for complete explanation of the function). Ensure that the door glass and gasket are kept clean and free of laundry when loading the machine. Have you selected an option that changes the spin profile ( or change of spin speed on the selector)?To reduce noise and vibration and improve the machine's reliability and life, the machine is fitted with an electronic sensor that detects if the load is unbalanced. [. . . ]