User manual HOOVER MAX EXTRACT

[. . . ] The plug must be inserted into an appropriate outlet (B) that is properly installed and grounded in accordance with all local codes and ordinances. (F) extending from the adapter must be connected to a permanent ground (G) such as a properly grounded outlet box cover. Whenever the adapter is used, it must be held in place by a metal screw. NOTE: In Canada, the use of a temporary adapter is not permitted by the Canadian Electrical Code. [. . . ] 15 Fill large Clean Water Tank (A) with hot tap Vacuum thoroughly - For carpet, use a HOOVER ® vacuum cleaner with an agitator for best results. Vacuum upholstery with a vacuum cleaner with cleaning tool attachments. Test for colorfastness - Wet a white absorbent cloth with the detergent. In a small, hidden area, gently rub the surface with the dampened cloth. Wait ten minutes and check for color removal or bleed with white paper towel or cloth. When cleaning entire floor, move furniture out of area to be cleaned (may not be necessary if only high traffic areas are to be cleaned). For furniture too heavy to move, place aluminum foil or wax paper under legs. To prevent staining, use plastic or aluminum foil to protect wood or metal surfaces from possible water spray. To avoid wetting and possible damage to wood floors underneath area rugs, either move area rugs to a non-wood hard floor surface or place waterproof material (e. Steps A through D should be performed in approximately 24 seconds for best results. For best cleaning and drying it is very important to perform steps A through D in one path before moving to the next section. wide (A) for treating high traffic areas and large spots and narrow (B) for smaller areas. Aim spot sprayer at problem area using the spot finder light as your guide. Always rinse areas that have been cleaned with the Spot Clean function, this removes the soils and the detergent from your carpet. Pull and hold solution trigger while pushing machine straight forward. Use for picking up small liquid spills (one gallon or less, never to exceed 1/8 in. Slowly move cleaner over the spill until liquid is no longer visible moving through the recovery nozzle. Washing or rinsing is recommended after picking up a spill in order to prevent resoiling. Set cleaning mode selector to "Wash / AutoRinse" for normal cleaning "Rinse Only" for plain water spray or "Spill Pick-Up" to remove small spills (will not spray in this mode). The surface selector can be set to either the carpet or rug cleaning mode, the tool will operate the same at either setting. Hose length may require that machine be placed at the top of the stairs to clean upper half of stairway and at bottom of stairs to clean lower half. To prevent machine from falling, use extra caution when cleaning on stairs. [. . . ] The service parts used in this unit are easily replaced and readily available from an authorized HOOVER® Dealer or retailer. Always identify your cleaner by the model number and manufacturing code when requesting information or ordering replacement parts. Do not send your cleaner to Hoover ®, in Glenwillow for service, this will only result in delay. If further assistance is needed, contact the Exclusive Hoover Platinum CollectionTM Member Services Line 1. [. . . ]