User manual HOOVER JAZZ SM18DL4 011

[. . . ] The charging LED indicator** will flash to advise that the product is charging. When the product is fully charged and is still positioned on the charger base, the icon will stop flashing and remain lit. The charging LED indicator** will illuminate red all the time to advise that the product is charging. When the product is fully charged and is still positioned on the charger base, the red led will remain on. [. . . ] To remove the batteries, please contact the Hoover Customer Centre or proceed according to the following instructions. Remove the wires which connect to the batteries one by one to make sure no short circuit. Note: Should you experience any difficulty in dismantling the unit or for more detailed information on treatment, recovery and recycling of this appliance, please contact your local city office or your household waste disposal service. 2 GB FEATURES A On/Off Switch** B LED Display* C LED Charging Indicator** D Removable Crevice Tool E Suction Inlet F Power Nozzle* G Dust Bin Flap H I J K L M N Charger Base Cardboard Ruler Charger Dust Brush Dust Bin Open Trigger Flexible Hose* Crevice Brush* STORAGE/CHARGING Unit Storage The product is designed to sit in the charging base on a flat surface or vertically if wall mounted. [1] For tidy storage wrap excess cord on the back of the charging base and exit either side or bottom. To Wall Mount (Tools required: Screwdriver and drill) 1. Place the cardboard ruler against the mounting surface. 4. Position base into the insert screws, and move down to ensure the base is fixed firmly to the wall. Charging & LED Indicator** Ensure the product on/off switch** button is at the “OFF” position, then place the cleaner into the base, ensuring the shroud covers the back of the product. The charging LED indicator** will flash to advise that the product is charging. When the product is fully charged and is still positioned on the charger base, the icon will stop flashing and remain lit. The charging LED indicator** will illuminate red all the time to advise that the product is charging. When the product is fully charged and is still positioned on the charger base, the red led will remain on. Note: Use only the charger supplied with your cleaner to recharge the unit. IMPORTANT: Before first use, charge your cleaner for at least 24 hours. It is normal for the charger to become warm to the touch when charging. If the operating time reduces after repeated use, let the cleaner run until it stops, then recharge for 24 hours and repeat this monthly for best results. Never charge the batteries in temperatures above 37°C or below 0°C. HOW TO USE 1. Remove the cleaner from the storage base. 2. Push the switch** to ‘ON’ position to begin cleaning and to turn off move the switch** to the ‘OFF’ position. 3. For the cleaner with Power Nozzle*, push the switch** to “1” position to begin cleaning and to turn off move the switch** to the “0” position, push the switch** to “Power Nozzle Icon ” to turn on the power nozzle. 5. To empty the bin pull the bin open trigger, the dust bin flap will open and stop about 45 °position for debris to empty easily. [2] IMPORTANT: for best results clean the filter after each use. LED DISPLAY* This cleaner is equipped with a LED display. [. . . ] Cloth Filter S103 35601645 Microfiber Filter S105 35601646 The Environment: The symbol on the product indicates that this product may not be treated as household waste. Instead it shall be handed over to the appliance collection point for recycling of electrical and electronic equipment. Disposal must be carried out in accordance with the local environmental regulations for waste disposal. For more detailed information about treatment, recovery and recycling of this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product. [. . . ]