User manual HOOVER HVH 5512

[. . . ] We are constantly striving to improve product quality and as such may modify appliances to incorporate the latest technical improvements. Installing a domestic appliance can be a complicated operation which if not carried out correctly, can seriously affect consumer safety. It is for this reason that the task should be undertaken by a professionally qualified person who will carry it out in accordance with the technical regulations in force. In the event that this advice is ignored and the installation is carried out by an unqualified person, the manufacturer declines all responsibility for any technical failure of the product whether or not it results in damage to goods or injury to individuals. [. . . ] THE CHOICE OF COOKWARE - The following information will help you to choose cookware which will give good performance. The sandwich base combines the benefits of stainless steel (appearance, durability and stability) with the advantages of aluminium or copper (heat conduction, even heat distribution). Aluminium residues sometimes appear as scratches on the hob, but can be removed if cleaned immediately. Good performance, but copper may leave residues which can appear as scratches. the residues can be removed , as long as the hob is cleaned immediately. Personal experience should then let you adapt these settings to your taste and habits. Melting heat 3 : Keeping hot 4 : Heating up 5 : Thawing, stewing, full cooking, low temperature cooking 6 : Cooking without lid 7 : Frying, meat browning and roasting 8 : High temperature cooking and roasting, seizing 9 : Frying, boiling large quantities of water. GENERAL STOP The cooking zones and the timer can be stopped at any moment by pressing for 3 seconds on the On-Off button. ⷠRESIDUAL HEAT INDICATOR The control panel tells the user when the surface temperature of the cooking zones exceeds about 60°C, by the following displaying: . When the temperature goes back below 60°C, the display goes off. For ending the cooking, we advise switching off the cooking zone and using the residual heat of the zone to finish cooking gently. After a cut in the current, the residual heat indicator disappears completely, even if the surface temperature exceeds 60°C. In the next 10 seconds - Press the button for the zone with the addition. TO STOP THE ADDITIONAL ZONE: - The cooking zone with addition must be live: in the display zone, the lamp must be on. The control LED near the heat level must be displayed, it shows that the zone is live. The programmed time can be modified at any moment by pressing the timer selection button, the timer control LED must be on. When the time has run, the cooking zone goes off automatically and an audible beep sounds for 1 minute. After powering up the hob, wait 8 seconds to activate the electronic controls. In each display zone the heat level is displayed and the control LED blinks. - After 10 seconds whithout use, the electronic control goes off and the starting operation has to be repeated. [. . . ] A technician should verify the fitting in compliance with the recommendations, page 2. This appliance is marked according to the European directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE). By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. The symbol on the product indicates that this product may not be treated as household waste. [. . . ]