User manual HOOVER HNWF 6167

[. . . ] Please read and follow these instructions carefully and operate the machine accordingly. This booklet provides important guidelines for safe use, installation, maintenance and some useful advice for best results when using your machine. Keep all documentation in a safe place for future reference or for any future owners. Please check that the following items are delivered with the appliance: Instruction manual Guarantee card Blanking plug Inlet hose & hooked end support (see Unpacking and Installation Instructions) Base panel & x2 push clips Energy Label Your local council will be able to give you details of current means of disposal. [. . . ] After selecting the programme and the required options press the Start Pause button once to start the machine. The STOP light will stop flashing and START light will illuminate and there will be a short time delay to the start of the programme while the machine sets the wash parameters for the selected programme and options. When starting a subsequent wash cycle the programme selector must be returned to AUS prior to the next programme being selected and started. the selection of the time is completed by pressing the Startzeitvorwahl button , the CHRONOVISION display will indicate the time selected. When the correct delay is selected press the Start Pause button to start the cycle. This option is particularly useful for heavily soiled loads and can be used before selecting the main wash programme. Detergent for this programme should be added to the first compartment of the soap drawer labelled "I" (Please refer to Detergent Drawer section of manual). The option increases the number of rinses to five (including the final conditioned rinse). This can help prevent skin irritation from detergent residue for people with particularly sensitive skin. Selecting the Extra Spülen button is also recommended when washing heavily soiled fabrics which need a lot of detergent, or when the wash load contains towelling fabrics that have a greater tendency to retain detergent. This option is available on the Cottons programmes (Kochwäsche, Buntwäsche, Mischgewebe), AA bei 40°C, Kurz 59' bei EEK A, Sportwäsche and Daily (Kurz 29', Kurz 44') programmes to reduce the maximum spin speed to 600rpm thus reducing creasing. It is not recommended that this option be selected when a drying programme will follow, as the length of the drying cycle will be increased. The washing machine is equipped with a temperature selector knob to set the temperature you require. Bigger energy savings can be achieved by using the lower temperature settings around the dial between and 40°C. By selecting the position, the wash temperature is limited to the water inlet temperature, thus reducing energy consumption further. We recommend that the temperature shown on wash care garments should never be exceeded. In the case where the temperature has been accidentally set higher than that of the chosen programme, (see Programme Guide table), the machine will lower the temperature automatically to protect the fabrics. Turn the drying time selector until the indicator aligns with the desired time. Note: If the drying time is selected before the wash cycle is completed the machine will automatically commence the drying programme. Refer to the Programme Guide to identify which drying programme will be automatically selected after the wash programme. The drying time can be reduced at any time during the cycle but cannot be increased. The times given are indicative and will vary with the exact level of dryness required (eg for ironing or ready to hang) and the size and composition of the load. [. . . ] If you have found any of the above problems correct them and run the machine through a spin cycle to drain the water. Ensure that the door glass and gasket are kept clean and free of laundry 33 Water has not drained from the machine?To reduce noise and vibration and improve the machine's reliability and life, the machine is fitted with an electronic sensor that detects if the load is unbalanced. To improve the spin performance the load can be re-distributed by hand at the end of the cycle and then re-spun. [. . . ]