User manual HOOVER HND 7102

[. . . ] By pressing this button, the selected washing programme is modified to get best performance from combined detergents (furthermore, the salt and rinse aid shortage lights are de-activated). Once selected, this option keeps being on (light on) also for next washing cycles and it can be de-activate (light off) only by pressing the button once again. Opening the door when a programme is running is not recommended especially during the main wash and final hot rinse phases. [. . . ] Dishes can now be removed and the dishwasher turned off by pressing the "ON/OFF" button or dishes can be loaded for a new cycle. In response to your everyday washing requirement in addition to the normal wash functions this dishwasher is equipped with the "1/2" function. This function enables the uses to wash a reduced number of dishes yet retaining the freedom of loading them both on the top and bottom basket. When this function is activated the dishwasher will automatically reduce the water and energy consumption and the wash time. If you open the door during the drying cycle, an audible audio signal advises you that the drying cycle has not yet finished. Dishwasher start time can be set with this button, delaying start from 1 to 23 hours. proceed as follows to set a delayed start: Press the "DELAY START" button ("00" will appear on the display). Press the button again to increase the delay in hours (each time the button is pressed the delay is increased by 1 hour to a maximum of 23). To start the countdown, press the selected programme button (the relevant indicator light will stop flashing and remain on and the start time delay will be shown in the display). at the end of the countdown , the programme will automatically start and the length of the selected cycle will be shown in the display. Proceed as follows to cancel a delayed start: Hold the selected programme button down for at least 5 seconds. Delayed start cancellation is confirmed when the selected programme indicator light starts to flash. The display will go blank and the programme end indicator light will light (any selected options will also be cancelled and the corresponding indicator lights will turn off). At this point, a new programme and option buttons must be set to start a new programme as indicated in the "PROGRAMME SETTINGS" section. The alarm for the programme end may be muted as follows: With the dishwasher off, hold down the second option button (from the left) while simultaneously pushing the "ON/OFF" button. "b1" will appear on the display to indicate that the alarm is on. [. . . ] * The softener unit is set in the factory at level 4 (d4) as this satisfies the requirements of the majority of users. Regulate the setting of your water softener unit according to the degree of hardness of your water as follows: 1. Each time you press that button the setting will increase by one level. [. . . ]