User manual HOOVER HED6612

[. . . ] As the gas is flammable, do not smoke or use an open flame during this time. This appliance complies with international safety standards, and is fitted with a plug with earth connection to ensure compl ete earthing of the product. Before connecting the appliance to the mains supply it is important to ensure: That the supply socket is properly earthed. That your electricity supply is capable of meeting the consumption requirements listed on the rating plate of your appliance. Ensure that your product is properly earthed. In the absence of adequate earthing you will notice that when touching the metal parts of your appliance an electrical dispersion can be felt, due to the presence of a radio interference suppressor. This appliance complies with Directives 89/336/EEC, 73/23/EEC and following changes. Do not abuse, sit on, or stand on the door or dish rack of the dishwasher. [. . . ] Remember, you should adjust the amount of detergent you use by small amounts until you find the correct amount. To remove hard water spots, try the following: Run di shes through a normal wash program. Remove all metal dishware, such as cutlery, pans, etc. , from the dishwasher. Pour two cups of vinegar into a bowl and set the bowl face up on the lower rack of the dishwasher. If this doesn't work, try the same process with 1 / 4 cup of citric acid crystals instead of vinegar. Dishwasher detergent is corrosive!Take care to keep it out of reach of children. Use only detergent specifically made for use in dishwashers. Don't put powder detergent into the dispenser until You're ready to wash dishes. The rinse aid is released during the final rinse to prevent water from forming droplets on your dishes that can leave spots and streaks. It also improves drying by allowing water to "sheet" off the dishes. The rinse aid dispenser is located inside the door next to the detergent dispenser. To fill the dispenser, open the cap and pour the rinse aid into the dispenser until the level indicator turns completely black. The dispenser holds about 100 ml of liquid rinse aid. To open the dispenser, turn the cap to the "open" (left) arrow and lift it out. Replace the cap by inserting it aligned with "open" arrow and turning it to the closed (right) arrow. Be careful not to overfill the dispenser, because this could cause oversudsing. Also, never use abrasive cleaners or scouring pads on the outer surfaces because they will scratch the finish. Some papers towels can also scratch or leave marks on the surface. Never use a spray cleaner to clean the door panel for it could damage the door l ock and electrical components. It is not allowed to use the abrasive agent or some paper towel becauseof the risk of scratching or leaving spots on the stainless steel surface. Something will occasionally move into the filters and the drain pump. If this occurs, the drain pumps employed in your dishwashers are designed to automatically reverse, ejecting the item back into the sump area or down the drain. If you have to remove an obstacle from the drain pump, before you remove the filters, you should turn off the power; Then remove the small black insert from the sumparea. Scoop out the item that is probably in the sump area and causes the obstruction. Remember to replace the black insert before you put the filters back in. After every wash, turn off the water supply to the appliance and leave the door slightly ajar so that moisture and odors are not trapped inside. Before cleaning or performing maintenance, always remove the plug from the socket. Do not run risks. When you go on holiday, it is recommened that you run a wash cycle with the dishwasher empty and then remove the plug from the socket, turn off the water supply and leave the door of the appliance slightly ajar. This will help the seals last longer and prevent odors from forming within the appliance. To clean the exterior and rubber parts of the dishwasher, do not use solvents or abrasive cleaning products. To remove spots or stains from the surface of the interior, use a cloth dampened with water and a little white vinegar, or a cleaning product made specifically for dishwashers. If the appliance must be moved, try to keep it in the vertical position. If absolutely necessary, it can be positioned on its back. One of the factors that cause odors to form in the dishwasher is food that remains trapped in the seals. Periodic cleaning with a damp sponge will prevent this from occurring. 9 Fused electrical supply is required-copper wire only. [. . . ] In this case, the wash cycle time will be shortened by about 15 minutes and the wash efficiency slightly reduced. The connection must be made to the hot water line following the same procedures as those for the connection to the cold water line. Position the appliance in the desired location. The back should rest against the wall behind it, and the sides, along the adjacent cabinets or wall. The dishwasher is equipped with water supply and drain hoses that can be positioned to the right or the left to facilitate proper installation. Once the appliance is positioned, adjust the feet (screwing them in or out) to adjust the height of the dishwasher, making it level. [. . . ]