User manual HOOVER HDPN 4S603PX

[. . . ] We are confident it will assist you loyally in washing your daily dishes in full safety. Carefully read this manual for correct and safe appliance use and for helpful tips on efficient maintenance. We recommend you always keep this manual to hand and in good condition for any future owner. Please check that the appliance is delivered with this instruction manual, the warranty certificate, the service centre address and the energy efficiency label. [. . . ] If they are blocked, clean them in the 1) to remove the upper rotor arm, turn it until it lines up with the stop marked by the arrow (fig. 1) and, keeping it pushed in, unscrew it in a clockwise direction (to reassemble it repeat the same operation, but turn it anticlockwise). 2); 2) wash the rotor arms under a jet of water to clear any blockage in the spray heads. After every wash it is essential to turn off water supply and to switch off the machine by pressing the On/Off button to the off position. If the machine is not going to be used for some time, it is advisable to follow these rules: 1. Do an empty wash with detergent in order to clean the machine of any deposits; 2. If the machine is left in places where the temperature is below 0°C any water left inside the pipes may freeze. Wait until the temperature rises above zero and then wait for about 24 hours before. Place settings (EN 50242) Capacity with pans and dishes Water supply pressure (MPa) Fuse / Power input / Supply voltage 10) "Total care" PROGRAMME INDICATOR LIGHT When the Total Care programme is enabled, the corresponding indicator light comes on. The display keeps you constantly informed 11) "HALF LOAD" OPTION INDICATOR On the operation of the appliance. 1) TEMPERATURE DISPLAY Indicates the washing temperature of each programme selected. 2) PROGRAMME DISPLAY Indicates set wash programmes, provides information on set options, reports any faults and so on. Touching the display in the first few seconds after you have plugged in the appliance could interrupt its selfcalibration procedure, thus jeopardising the appliance's proper functioning. 3) TIME REMAINING DISPLAY Indicates the wash time for each selected programme and provides the time remaining to the end of the programme. At the end of the cycle, remember to switch off the appliance using the ON/OFF button, then remove the plug and close the water supply. 4) WATER SUPPLY CLOSED INDICATOR LIGHT Indicates any fault in the inflow of water between the tap and the dishwasher (see "TROUBLESHOOTING AND WARRANTY"). First time you switch on the appliance L When you have connected the appliance to the mains and switched it on via the Start/Reset button, "ENGLISH" will appear on the display. l Select the language desired by pressing The HALF LOAD and EXTRADRY buttons, then confirm your selection by pressing the "Start/Reset" button. L A "WELCOME" message will appear on the display for 5 seconds. From the settings menu, you can adapt various parameters to your washing needs. The dishwasher must ALWAYS be off l Follow the steps detailed in the Before you start this procedure. Button down and at the same time press the ON/OFF button for 3 seconds. [. . . ] In this case, turn the dishwasher off by pressing the "ON/OFF" button. After checking to make sure the water supply is open, that the drain pipe is not bent and that the siphon or filters are not clogged, set the selected program again. This dishwasher is equipped with an overflow safety device that, in the event of a problem, automatically discharges any excess water. To ensure the correct operation of the overflow safety device, we recommend not moving or tilting the dishwasher during operation. [. . . ]