User manual HOOVER HC 75 XT,MV

[. . . ] Make sure it is out of the reach of children, it is a potential source of danger. Check that no damage has occurred to the machine during transit. Failure to comply with the above can compromise the safety of the appliance. You may be charged for a service call if a problem with your machine is caused by misuse. SAFETY REMINDERS Use This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance. [. . . ] There should be a gap of at least 12mm between the machine and any obstructions. Prevent items from falling or collecting behind the dryer as these may obstruct the air inlet and outlet. NEVER install the dryer up against curtains. You may be charged for a service call if a problem with your machine is caused by incorrect installation. If the mains cord on this appliance is damaged, it must be replaced by a special cord which is ONLY obtainable from the spares service. It must be installed by a competent person. CE Appliance complies with European Directive 89/336/EEC, 73/23/EEC and subsequent amendments. Adjusting the Feet Once the machine is in place the feet should be adjusted to ensure that the machine is level. Do not plug the machine in and switch it on at the mains until the installation is completed. For your safety, this dryer must be correctly installed. If there is any doubt about installation, call GIAS Service for advice. EN 5 VENTILATION Installation of the Discharge Hose It is essential to use a venting hose to carry the hot moist air away from the dryer unless the dryer is situated in a open space with a good air flowaround it. Recirculation of the moist air will prevent the efficient operation of the dryer. The hose may be fitted through a wall or through an open door or window. The following guidelines should be followed when installing the discharge hose. Do not use two hoses joined together as the drying performance will be reduced. by kinking it or fitting a smaller diameter connector to mount to a wall opening. For small loads and separate items or pre-dried fabrics with low moisture content, use the timed programmes. If the sensor does not detect the item the dryer will only operate for 10 minutes before going into cooldown. If the load is too large or too wet to tumble dry the dryer will automatically go into cooldown after approximately 3 hours. The 20 minutes selection time in only cool air ventilation (Refresh) Memo Program allows to re-perform a program that the user has saved before, without selecting the correct sequence of program selector positions and option buttons for that particular program. Memo EN 9 DOOR and FILTER Opening the Door Pull on handle to open the door. To restart the dryer, close the door and press Start/Pause button . WARNING!Never stop a tumble dryer before the end of the drying cycle unless all items are quickly removed and spread out so that the heat is dissipated. OPERATION 1. Gently close the door pushing it slowly until you hear the door 'click' shut. Turn the Programme Selector dial to select the required drying programme (see Programme Guide). If drying synthetics, acrylics or delicate items, press the Acrylic Synthetic button to reduce the heat level. To deselect in the first few minutes of the programme, press the Acrylic Synthetic button , after this time reset the machine to change the setting. The dryer will start automatically and the indicator above the button will be continuously lit. [. . . ] The Drum, door and load may be very hot. EN 11 TROUBLESHOOTING What Might be the Cause of. . . Defects you can remedy yourself Before calling GIAS Service for technical advice please run through the following checklist. A charge will be made if the machine is found to be working or has been installed incorrectly or used incorrectly. If the problem persists after completing the recommended checks, please call GIAS Service, they may be able to assist you over the telephone. The time to end is continuously checked during the drying cycle and the time is adjusted to give the best estimation time. [. . . ]